|
|
Cessna Glare Shield Cover by
Al Gilson
The glare shield in our 64 Skyhawk is original, therefore not the most
pristine to look at. Is there a cover available, such as the carpet
covers you see for autos/trucks, available for airplanes?
Yes, I know I can get a $200+ plastic cover rom Selkirk or others that
covers the entire glare...
|
|
4 |
5,217 |
|
|
Cessna landing light switch by
[email protected]
I have a C-172B that has the dual landing lights in the wing. The first
position on the pull-out light switch turns on only the taxi light (at
least I assume it is for taxi as it is aimed so low) and the next
position turns on both (landing and taxi). Does anyone know if there is
a legal...
|
January 12th 06 12:19 PM
by Denny
|
1 |
1,497 |
|
|
Cessna landing light switch; solved! by
jim
I had asked if anyone knew of a replacement Cessna landing light switch
that would turn on the taxi light and landing light separately (not
both on the second pull-out notch so as to ease the electrical load
during low RPM). I had given up and was going to take Denny's advice to
remove the existing...
|
January 15th 06 10:33 PM
by Newps
|
1 |
1,173 |
|
|
CESSNA LSA by
john smith
According to AvWeb, Cessna says they are going to have a hard time
producing their LSA for under $100,000.
That's not going to sell well.
Then again, I may be wrong!
( 1 2)
|
August 9th 06 07:46 PM
by ET
|
11 |
935 |
|
|
Cessna LSA -- Good Luck if you want one by
C J Campbell[_1_]
Cessna is rationing their LSA very strictly. Each dealer gets exactly
one! If you want a Cessna LSA you AND your dealer, apparently, have to
go to Oshkosh with a $10,000 deposit one week before the show and meet
with a Cessna representative. There are no hotel rooms available and
Cessna will...
( 1 2 3)
|
|
26 |
2,106 |
|
|
Cessna Muffler Shroud by
RST Engineering
I've exhausted all my sources for a Cessna muffler shroud without paying
through the nose to Cessna itself.
Cessna 182A used a muffler 0750130-12 with a shroud 07501030-13. My shroud
is pretty much toast, especially considering how it got thrashed about in
our little difficulty in Wyoming last...
( 1 2)
|
|
13 |
1,285 |
|
|
Cessna N734AE VFR Flight with ATC COMS - Video by
A Lieberma[_2_]
Cessna N734AE VFR Flight with ATC COMS - Video
Me acting like a noob as a passenger on todays VFR flight to
Brookhaven MS.
http://www.youtube.com/watch?v=pjmjttvrRN8
An exclusive video probably not to be seen anywhere else on You Tube
(that is an aerial shot of the snow cover) The squeals of...
|
|
0 |
1,457 |
|
|
Cessna news. by
John[_9_]
Cessna was the high bidder for the assets of Columbia aircraft. They
will keep the plant open and rebadge the aircraft as the Cessna 350
and 400.
Cessna will also apparently keep their NGP concept aircraft in process
with a long term goal of replacing the current high wing series with a
new...
|
|
0 |
417 |
|
|
cessna nose oleo by
Air Lachute inc
I am looking for heavy-duty seals to replace standard o-rings in cessna single engine nose strut.Collapsing and leaking problems...I have heard about cold weather seal and square-ring but I'm still searching for P/N and specs. THANKS
|
|
0 |
2,720 |
|
|
Cessna nose oleo seals by
[email protected]
In the Cessna 172's nosewheel strut are several O-rings, but the
one that seals against the chrome piston sometimes twists in its groove
and a spiral failure (tear) occurs. All the outer-cavity oil escapes,
then the nitrogen leaves and the strut goes flat. The failure appears
to happen rather...
|
|
4 |
1,404 |
|
|
Cessna PTT switch normal? by
Mark Hansen
We have a plane in our club (1978-ish C172N) that has a problem
with the pilot's push to talk switch. It is mounted on the yoke
handle (as if from the factory, not like an after market).
When you press it gently, it works fine. If you press it too hard,
the radio continues to send the carrier, but...
|
|
9 |
3,279 |
|
|
Cessna seat rails by
Javier Henderson
May I refer you to:
http://www.kjsl.com/~javier/sb-1.pdf
http://www.kjsl.com/~javier/sb-2.pdf
http://www.kjsl.com/~javier/ad-1.pdf
http://www.kjsl.com/~javier/ad-2.pdf
That deals with the seat rails on Cessna single engine aircraft. It's
pretty straightforward, when the holes on the rails are...
|
|
9 |
5,254 |
|
|
Cessna Service Bulletin SEB94-8 by
[email protected]
Hi,
We just had our annual done on our 172E, and there were cracks found in
the forward horizontal stabilizer spar. The remedy is to apply Cessna
Service Bulletin SEB94-8.
Does anyone know where I can obtain a copy of this bulletin online?
I'm trying to get an idea of the cost of this...
|
|
5 |
6,563 |
|
|
|
February 25th 04 02:25 AM
by UTAH
|
0 |
1,138 |
|
|
Cessna Turbo 310 Riley Rocket by
O. Sami Saydjari
Does anyone know anything about the "Riley Rocket" version of the Cessna
Turbo 310? I am getting claims of "260 KTAS at 20,000 feet burning only
24 gph total." Does that make sense? Seems a little too good to be
true. Does anyone have actual experience with a Riley Rocket that
matches this...
|
|
4 |
6,337 |
|
|
Cessna Wheelpants by
Tom Cummings
I need to repair the stock Cessna wheelpants for my 1973 Skyhawk. Splits,
freyed edges, scrapes, etc.
What is the proper type of cloth and resin to use?
Thanks,
Tom Cummings
|
|
1 |
370 |
|
|
Cessna window latch by
karl gruber
I just saw an ad for a reproduction window latch. Now I can't find it
when needed. Does anyone remember who is making them?
Best,
Karl
"Curator" N185KG
|
September 27th 05 06:14 PM
by Newps
|
1 |
2,771 |
|
|
Cessna Wing Jig by
Clay
A couple of A&P and IA buddies of mine and I have been discussing wing
rebuilding possibilities.
Does anyone have plans or know where to obtain plans for a Cessna wing
jig?
Are there jigs available for rent or sale near Wichita?
The wings we are interested in are for 150, 152, 172, 175, and...
|
December 17th 03 01:56 PM
by Clay
|
0 |
1,641 |
|
|
Cessna wing jig plans by
Clay
Does anyone have plans or know where to obtain plans for a Cessna wing
jig?
How much is an old jig worth (factory or fabricated)?
|
December 21st 03 03:57 PM
by Clay
|
0 |
1,175 |
|
|
Cessna Wing Skins by
Tom Cummings
My Cessna 172 M (1973) is being annualed. The top wing skin panels above the
wing tanks (Standard tanks) have to come off to inspect the area for
corrosion. We got all the screws removed. According to the service manual,
that is all that is supposed to be securing the panel. (Dozens of...
( 1 2)
|
April 26th 05 12:54 PM
by Jon A.
|
15 |
2,191 |