|
|
|
|
48 |
2,371 |
|
|
Stupid question about autogas by
Paul Folbrecht
If I buy a 152 getting the autogas STC appeals to me a lot for the
obvious reason (economy).
What I'm wondering about is exactly how the pilots that are running
autogas are getting it to the airport. I can't imagine the typical
answer is much different than "carting it there in cans" but even a...
( 1 2 3 ... Last Page)
|
|
34 |
2,370 |
|
|
FS: Bendix/King Skymap IIIC Color GPS by
NW_Pilot
Selling my Skymap IIIC GPS because I am needing funds for upgrading to
another make and model of GPS/EFB!
I have used this unit and is in almost New condition (Normal Scratches)
works great but it is time for me to upgrade to an electronic Flight Bag
type GPS.
Retails New For $2,279.00...
|
|
0 |
2,369 |
|
|
Need Source for Slip-On Foam Yoke Grips by
Carl Orton
I've seen slip-on black foam grips that you can use on the skinny mid-60's
Cessna control yokes.
I'm not talking about the leather wrap covers - these are like an open-cell
spongy foam that just slips over the yoke "horns".
I've searched King, Sporty's Aircraft Spruce, the archives, all to no...
|
|
6 |
2,369 |
|
|
Garmin GpsMap 396 - Flight Test by
Mike Spera
Made it up in the air today. Scattered cells and rain all over the
place. Mostly, moving out and clearing. 30 seconds after take off, lost
the GPS sat lock. Took about 15 seconds to regain it. In the next 5
minutes, it lost lock several more times. I'm thinking, external antenna
is loopy. I...
( 1 2 3 ... Last Page)
|
|
36 |
2,369 |
|
|
|
|
13 |
2,367 |
|
|
Softcomm panel mount intercom? Junk? by
[email protected]
I'm in the market for a 4 place panel mount, stereo intercom and am
looking at options. I understand installation is going to cost more
than the intercom so am thinking that a prewired harness would be a
good thing. Would really like to put in a PS Engineering or NAT
Intermusic, but by the time I...
( 1 2)
|
November 26th 05 06:46 AM
by spyfly
|
10 |
2,367 |
|
|
ILS approach to near minimums - Video by
A Lieberma[_2_]
First time for me going down to near ILS minimums by myself. Video
includes how I brief my IFR approaches.
http://www.youtube.com/watch?v=NCk_RRMemnM
Video I think does a good job on demonstrating why the runway may not
be always exactly in front of you after wind correction angle
considerations...
|
|
0 |
2,366 |
|
|
"Aircraft Paint & Prep Booth" experiences? by
Hi all; I'm wondering if anybody here has any experience with "Aircraft
Paint & Prep Booth" at the Corona airport in Southern California.
How was their work? Did it hold up over time?
Also, someone has told me there's a good paint shop at the Sebring,
FL airport, but couldn't remember its name. ...
|
November 23rd 03 02:23 AM
by
|
0 |
2,366 |
|
|
Northern NJ Flying Club Accepting New Members by
Andrew Gideon
Hello all. I've mentioned my flying club a number of times, and...
A limited number of memberships are available in The Paramus Flying
Club, which has been providing affordable flying in Northern NJ since
1955.
Today, the club spans two airports and flies four aircraft: two 180HP
Cessna 172s, a...
|
|
0 |
2,365 |
|
|
Engine preheater on ebay?? by
skym
There's a portable engine preheater on ebay motors for $129. It looks
like an ok unit but I'm asking for any of the collective wisdom on pros
or cons of a unit like this. There's also one on Sportys for $399.
Any opinions on either or a comparison?
( 1 2 3)
|
|
20 |
2,361 |
|
|
cost to install engine analyzer (4 cyl)? by
dlevy
Anyone had a 4 cylinder engine analyzer installed lately? I'm thinking
about an EDM-700 on a Lycoming O-320-E2C in a Beech Musketeer and was
wondering about install costs.
( 1 2 3)
|
|
25 |
2,361 |
|
|
Vibration Testing by
Jim Weir
I've come across a marvelously cheap vibration sensor that I want to convert
into an engine vibration instrument for a Kitplanes article. The electronics
for me is relatively trivial...the mechanics of vibration are a little harder to
fathom.
From a mechanical engineering point of view on a...
( 1 2 3)
|
|
21 |
2,360 |
|
|
Proposed costs may endanger small air services by
Guv Bob
Anyone know anything about this? The video says new taxes and fees have been proposed for general aviation and it could shut down service to small airports.... The usual gloom and doom lobby stuff.
There's nothing specific on the website except to "send money." Do you know what "new...
|
|
4 |
2,359 |
|
|
C-182 or C-1820RG, or C-210.... by
[email protected]
I'm thinking of buying a 182 or 182 RG.
I like cessnas and the 182 is such an honest airplane it's hard to beat.
I'd just like it to be a bit faster.
If all of the speed mods are done to a normal C-182 , Good wheel pants, speed fairings, gap seals etc.....
how fast is it?
For comparision how...
( 1 2 3)
|
December 8th 03 03:29 AM
by Newps
|
22 |
2,357 |
|
|
stall strips ??? by
Tri-Pacer
I've noticed stall strips installed on a number of low wing aircraft.
However I've never noticed them installed on a high wing.
How come? Is there something inherent in the design of a high wing that
insures the stall starts at the wing root?
Or perhaps they're out there and I've just not...
|
December 8th 06 06:18 PM
by jls
|
6 |
2,354 |
|
|
Marker Beacon Tones by
Ron Natalie
"Jeff P" wrote in message ...
Where do marker beacon tones come from? Are they generated in the
receiver or are they transmitted from the ground station. I ask
because sometimes I see my lights blinking, but I don't...
|
|
1 |
2,353 |
|
|
Piper 235 tail skin by
Ross
Jay and other owners of this aircraft. Any documentation on cracks
forming on the horizontal tail surfaces. The -235 I am helping on annual
had three additional cracks in the skin beyound the two that were
repaired by the previous owner. Got some old skin and made conforming
patches.
--...
( 1 2 3)
|
|
26 |
2,350 |
|
|
Bendix King GPS Updates by
Matthew Waugh
I'm looking for information, feedback, pitfalls of updating Bendix-King
GPS's such as the KLN-89B and KLN-94 by updating the cards directly as
opposed to plugging into the GPS itself. I understand that there is a card
reader you can buy and that there is a firmware upgrade to it that allows
the...
|
|
1 |
2,349 |
|
|
Panel lights breaker pops by
Steve - KDMW
Has anyone seen this?...1974 Warrior panel lights don't come on, and
when I turn the rheostat past a certain point (almost full bright) the
panel lights breaker pops. I'm thinking it's the power transistor, at
least that's what I'm going to try first (along with cleaning the
rheostat) since it's...
( 1 2)
|
|
12 |
2,348 |