A aviation & planes forum. AviationBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » AviationBanter forum » rec.aviation newsgroups
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Post New Thread
Threads in Forum : Home Built Forum Tools Search this Forum Feed Icon
  Thread / Thread Starter Last Post Reverse Sort Order Replies Views
Canard static port location by Paul Lee
Where do you canard owners locate your static pressure ports? The SQ2000 has a handy spot for the ram air pitot port at the front. But where would be a good place for static port. The SQ2000 fus. tapers evenly until it reaches the door - where the body is parallel to...
July 12th 03 02:55 AM
by DBryan Go to last post
1 798
SUV thing by Fastglasair
I'm hoping he'll tell the rest of us the answer to that SUV thing. :-) What is the SUV thing?
July 12th 03 05:32 AM
by Barnyard BOb -- Go to last post
4 774
Guns & Common Sense by Veeduber
From: Veeduber ) Subject: Geezer's answer to Newbie questions View: Complete Thread (3 articles) Original Format Newsgroups: rec.guns Date: 1997/07/09 Dear Newbie,
July 12th 03 05:58 AM
by Barnyard BOb -- Go to last post
1 453
Looking for web addrress by Errol Groff
Last year, after Oshkosh, someone posted a web site that had a very nice collection of photos in a slide show sort of format. They showed, in part, the planes around his in the show plane parking area. One of the photos was a DC 3 I believe firing up its' engines with a great cloud of smoke. I...
July 12th 03 07:27 AM
by David O Go to last post
1 462
Stick and Rudder's 'Safety plane' by Barnyard BOb --
Ernest Christley misfired the following: I'm about halfway through this book. It is quite an eye opener. The author's explanations seem so insightful, cogent and complete. However, there's this one blemish. Printed in 1944, the author makes the claim that the rudder will disappear in just a...
(Multi-page thread 1 2 3 ... Last Page)
July 12th 03 04:13 PM
by Ace Pilot Go to last post
31 1,499
Propeller by Jan Carlsson
There is a computer design program on my web-page www.jcpropellerdesign.com The program also content a help page. Also, Eric Clutton's booklet have some good praktical tips. best Jan Carlsson "AWV" skrev i meddelandet ... I would like to...
(Multi-page thread 1 2)
July 12th 03 10:36 PM
by dann mann Go to last post
11 1,207
Change in TAS with constant Power and increasing altitude. by Big John
Chris At you talking about throtttle setting?. To hold the same % POWER as you climb, you have to advance the throttle until you get WOT from which point the % power decreases as you continue the climb. Big John Point of the sword On Thu, 10 Jul 2003 23:10:39 GMT, Chris W wrote:
July 13th 03 03:29 PM
by Kevin Horton Go to last post
6 988
Arlington trip by C J Campbell
Three of my students and I took the 206 to Arlington yesterday. We had to go IFR since the ceiling at Tacoma Narrows was only 400 feet. However, we broke out on top at 1400 and sailed under clear blue skies to Arlington, which was clear below 11,000. I was concerned about getting in there IFR and...
July 13th 03 04:00 PM
by C J Campbell Go to last post
0 657
Pack guns in your little airplane by Rich S.
"pac plyer" wrote The same could be done for part 91 flight. We could all write Phil Boyer at AOPA and Paul Jr. at EAA and suggest arming ourselves at little airports across America. This would keep non-flying TSA drones out of our hair while at the same time...
(Multi-page thread 1 2)
July 13th 03 05:45 PM
by Peter Gottlieb Go to last post
17 848
T88 by Adair
So can one use T88 to glue bell cranks to spars on flaps?
July 13th 03 07:09 PM
by Orval Fairbairn Go to last post
1 497
Chewed-up coupling connector - How-to? by Michael Horowitz
Folks - The oil pressure sensor/tube is secured to the engine block of my A-65 by a brass connector which is getting pretty chewed up; Over the years previous owners apparently using something other than the correct tool to tighten it down. I'm told (please correct me if my understanding is...
July 13th 03 08:42 PM
by Cy Galley Go to last post
3 627
Port Orchard (4WA9) by Rich S.
I found out yesterday that Port Orchard airport (4WA9) will temporarily close tomorrow, July 14, for two weeks or so. The owners are ripping out the existing blacktop and going to repave. The taxiway was taken out Friday. It's the "or so" that bothers me. I can only hope the project is...
July 13th 03 10:15 PM
by Rich S. Go to last post
4 504
Is there a trick for installing a Tinnerman spring nut? by Michael Horowitz
Folks - I know that if I get someone to sit inside and hold the flat Tinnerman fastener, I can screw in a machine screw from beneath the a/c. This is not the type of fasterner that clips on to the edge of the metal. For one person trying to either install or remove a screw from the afore mentioned...
July 14th 03 04:01 AM
by Craig Go to last post
9 1,301
Gasflow of VW engine by Veeduber
Has anyone had any experience with the "gasflow" of VW engine to improve horsepower at lower RPM? ------------------------------------------------- If by 'gasflow' you mean volumetric efficiency, I've some experience in that area. I'll also assume your question hinges on the fact that maximum...
July 14th 03 08:06 AM
by Andre Go to last post
4 2,081
>>> The Best FREE Manual for Affiliates by Master Affiliate
Ken Evoy must be bonkers - or the smartest marketer around. He's just spent three months writing a 224-page manual for affiliates, telling you, step-by-step, how to succeed with revenue sharing programs . . . And now he's giving it away. All you have to do to get the complimentary manual...
July 14th 03 12:11 PM
by Andre Go to last post
1 1,225
Exhaust for VW motor by Andre
I am wondering... My Sonerai has 4 stub exhausts cut to a 45 degree angle facing forward for some back presssure. I want to add some silencers to my setup. (Maybe one on each side...) Is it important that the distance from each cilinder exhaust port to the silencer is exactly equal or can I have...
July 14th 03 03:14 PM
by Andre Go to last post
0 678
aeroturtle - how to contact? by HankL
Anyone have phone number or contact info - thanks
July 14th 03 07:54 PM
by Dennis E. Senol Go to last post
1 603
Report from Arlington by Rich S.
At Arlington today, the following rah ilk were spotted, foraging amongst the dry grass and halter tops: Ron "the Red" Waantaja was seated in a custom 3" high lawn chair emblazoned with a Flybaby logo - under Moonraker's wing. He seemed kind of low. John Ousterhout, having spent the night with...
(Multi-page thread 1 2)
July 14th 03 10:23 PM
by O-ring Seals Go to last post
15 1,216
Uber Hackers by RobertR237
In article , writes: I was just wondering, are the uber hackers still on RAH? I have a problem with windows XP that nobody's been able to fix. I have a good suggestion but I doubt that you would take it.
(Multi-page thread 1 2)
July 14th 03 10:50 PM
by Frederick Wilson Go to last post
12 618
Airmaster Gone? by Calvin R. Walker
Hello All, I've heard a rumor that Airmaster, the NZ maker of electric variable pitch propellers, is no longer around or on its last legs. Can anyone verify this please? Calvin
July 15th 03 01:53 AM
by Martin Eskildsen Go to last post
1 557
Post New Thread


Display Options
Showing threads 61 to 80 of 6875
Sorted By Sort Order
From The
Forum Tools Search this Forum
Search this Forum :

Advanced Search

New posts New posts More than 15 replies or 150 views Hot thread with new posts
No new posts No new posts More than 15 replies or 150 views Hot thread with no new posts
Closed Thread Thread is closed  
 
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT +1. The time now is 02:52 PM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
Copyright 2004-2017 AviationBanter.
The comments are property of their posters.