A aviation & planes forum. AviationBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » AviationBanter forum » rec.aviation newsgroups
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Post New Thread
Threads in Forum : Home Built Forum Tools Search this Forum Feed Icon
  Thread / Thread Starter Last Post Reverse Sort Order Replies Views
Nothing to see here ...move along folks. by Montblack
Can we wrap up this recent spate of Juan stuff, and start fresh for 1-1-07? I'm just saying... Montblack Ok then, I'll start a thread with something (fun) RAH related.
December 30th 06 01:41 AM
by Montblack Go to last post
0 817
intercom circuit Jim Weir by hedley
Dear Sir , Complements of the season. I am a 50 year old pilot who has an ultralight , 2 place with a Filser radio and want to incorporate the following -: Audio input from an IPOD * Input 1 Normal VHF radio comms * Input 2 which must override / auto mute the input 1.
December 29th 06 06:39 PM
by RST Engineering Go to last post
1 743
This is worth the bandwidth by Paul Tomblin
In a previous article, Richard Riley said: This is the best piece of corporate communication I've seen in a long while. http://www.youtube.com/watch?v=Sz6XjXu-oT8 I'd find this a lot funnier if they hadn't laid off two of my Digital Cinema Management System developers...
December 29th 06 03:12 PM
by Gig 601XL Builder Go to last post
6 499
Etching copper clad by Ernest Christley
Getting ferric chloride from Radio Shack is getting problematic. Is there a common household chemical that I can use for etching a circuit board or two? I seem to remember Jim Weir having an article about how to do it in the not to distant past, but I can't find anything about it in my back...
(Multi-page thread 1 2)
December 29th 06 12:42 AM
by Ernest Christley Go to last post
13 899
Collins GLS 350 info by Sandy Barber
I have a narco MK12d cessna and an In-525b that I would like to use with a collins GLS 350 The info I have found tells me they both use 2 of channeling, but the pin out diagram for the GLS350 refers to the chanelling as BCD ??? Can this be done?
December 29th 06 12:05 AM
by Sandy Barber Go to last post
0 875
Hmmm a BD5J with zero hours FS by Juan Jimenez
wrote in message ... Geez, you will be in Singapore in March. Let me know when,Singapore is only a $12.00 ferry boat trip from Batam. It takes about an hour and I make the trip quite often. It would be really...
December 28th 06 03:17 PM
by Juan Jimenez Go to last post
2 580
Paul Tomblin by Juan Jimenez
Paul, If you have a beef with me and you feel strongly enough about it to post on Wikipedia, you should, at the very least, make sure you have a something approaching a clue when it comes to the subject on which you are commenting. Not following this simple guideline can make you look very...
(Multi-page thread 1 2 3)
December 28th 06 01:05 AM
by DABEAR Go to last post
28 1,007
Filling Aluminum by Lou
So,,, say you have an aluminum landing gear and the holes are not drilled correctly. Is there a good and bad way to fill these so they can be redrilled? Lou
December 27th 06 02:41 AM
by pbc76049 Go to last post
3 461
Narco Mk 12D display by [email protected]
Anyone have a source for parts (namely, the display) for a Mk 12D rather than having the factory do it? They won't sell the part seperatly. Jim
December 26th 06 11:33 PM
by [email protected] Go to last post
0 397
Jacksonville, FL Update by Jim Carriere
The first link just showed up in my email, I found the second one using the newspaper's search feature. Bad news: http://www.eaa.org/communications/eaanews/061220_ordinance.html http://www.jacksonville.com/tu-online/stories/121706/met_6806110.shtml
December 25th 06 10:58 PM
by [email protected] Go to last post
1 332
Flying to Canada in experimental by abripl
I am interested in flying to Canada from US in my experimental (after winter). Two questions. 1. I already got a copy of Transport Canada "STANDARDISED VALIDATION OF A SPECIAL AIRWORTHINESS CERTIFICATE - EXPERIMENTAL,....." permit. But section 9 says "except when otherwise directed by Air...
December 25th 06 07:53 PM
by Drew Dalgleish Go to last post
2 764
A-65 Oil screen thread pitch? by Scott
Doe anybody know what the thread pitch for the oil screen is on a Continental A-65? I have slightly boogered threads on the engine threads and I want to run a set of dies through (I bought a tool with the dies from McMaster Carr). It looks like 16 TPI is the closest. Does that sound...
December 25th 06 12:19 PM
by Scott Go to last post
8 554
Build a flying body wing by abripl
December 25th 06 03:57 AM
by J.Kahn Go to last post
1 523
Autopilot Porpoises when Mike Keyed by jls
Also instrument needles go crazy. Aircraft is a Lancair with antenna hidden in the horizontal stab. How 'bout directing us to some reading material about how to stop it. Our local avionics guy says we may have to live with it, or install external antennas, which will dirty up a Lancair in a...
December 24th 06 08:30 PM
by jls Go to last post
7 418
Z's network? by TSS7
Is it the general consensus that Zoom's Aero News Network is not completely trustworthy? It would seem he is just re-posting news he gets from some source. But I wonder if he doesn't "doctor up" the articles himself. If he's doing that, then they should throw him off the internet. I wonder if there...
(Multi-page thread 1 2 3 ... Last Page)
December 24th 06 05:03 PM
by Juan Jimenez Go to last post
66 2,090
Smart Turbo Diesel or VW Lugo Diesel by bbutlergps
Howdy, I am looking into a power plant for a Zenith 701. I am very interested in going the route of a diesel. Would anybody have any information on either the: Smart (Mercedes) 3 cyl. 95 hp Turbo Diesel (can be chipped up to 112 hp) found in the Smart ForFour or VW Lupo or Fox (euro) 3 cyl....
(Multi-page thread 1 2 3 ... Last Page)
December 24th 06 08:40 AM
by Philippe Vessaire Go to last post
66 9,711
This is worth the bandwidth by [email protected]
This is the best piece of corporate communication I've seen in a long while. http://www.youtube.com/watch?v=Sz6XjXu-oT8 THAT was awesome... -- Jay Honeck Iowa City, IA Pathfinder N56993
December 24th 06 01:36 AM
by [email protected] Go to last post
0 504
Can I build one of you items? by Gig 601XL Builder
I'm getting closer to the point where I will be working on the panel of my 601XL and I need to ask you a question. I have little to know electronics experience. Of course I'd never had any metal working experience and I think I'm doing a pretty good job on my plane. So the question is how much...
December 23rd 06 08:21 AM
by Montblack Go to last post
3 673
Little bears make lousy wannabe's :) by Juan Jimenez
This is just hilarious. This putz claims he publishes his address on all his sites. The truth is that this dip**** coward is lying, his address is actually located in his domain record for his sites. Funny thing is, the address he says he makes public actually points on google maps to the...
(Multi-page thread 1 2)
December 23rd 06 01:20 AM
by Juan Jimenez Go to last post
11 701
Jim Weir - desulfating battery charger by Ernest Christley
Jim, that was an excellent article in last month's kit plane. I'll be getting the parts together to build one here shortly. There was also a nice article in Sport Aviation (for a change), that actually showed how to build something. In this case a battery desulfator. The question is, how...
December 21st 06 10:28 PM
by Ernest Christley Go to last post
5 3,253
Post New Thread

Display Options
Showing threads 2021 to 2040 of 6893
Sorted By Sort Order
From The
Forum Tools Search this Forum
Search this Forum :

Advanced Search

New posts New posts More than 15 replies or 150 views Hot thread with new posts
No new posts No new posts More than 15 replies or 150 views Hot thread with no new posts
Closed Thread Thread is closed  
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

All times are GMT +1. The time now is 04:30 PM.

Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.
Copyright 2004-2019 AviationBanter.
The comments are property of their posters.