A aviation & planes forum. AviationBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » AviationBanter forum » rec.aviation newsgroups
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Post New Thread
Threads in Forum : Owning Forum Tools Search this Forum Feed Icon
  Thread / Thread Starter Last Post Reverse Sort Order Replies Views
Garmin 95 antenna needed by Marty from Florida
Does anyone have a drawer with accessories for a Garmin 95? I need an antenna + interface cable and yoke mount if available. Please reply to this post, or send info to: martysummer at hotmail ...... do..t. com Thanx in advance.
February 19th 06 08:48 PM
by Marty from Florida Go to last post
0 257
Ping: Toecutter by Bob Chilcoat
My Hershey-Bar wing Archer is in for annual. Today they found a crack in the left wing aileron bellcrank support. Sounds dangerous. It's going to need replacing. Any idea if this is as big a job as it sounds like? Will the wing skins need to come off? Anyplace I can find a drawing of...
(Multi-page thread 1 2)
February 18th 06 10:08 PM
by Jack Allison Go to last post
19 431
Mixture control bottoms-out against the firewall? by Mark Hansen
I have a maintenance question. I read somewhere that the mixture control should not bottom-out against the firewall when full rich, as the pilot would not be able to tell if the full-rich position was achieved, or if the knob just hit the firewall stop. However, I'm wondering if this is just a...
(Multi-page thread 1 2)
February 18th 06 01:52 PM
by Ron Natalie Go to last post
11 482
TRT-250 manual by kennyt1123
Can you please send me the PDF of your TRT 250 manual to ? Thanks so much.:) -- kennyt1123 ------------------------------------------------------------------------ Posted via OziPilots Online http://www.OziPilotsOnline.com.au ] - A website for Australian Pilots regardless of...
February 18th 06 01:49 AM
by Juan Jimenez Go to last post
1 457
Cessna 150 @ $11,245 per hour by mce
Well, at least that's my cost basis since I've only put on a little under 2 hours so far for the demo flight and the short hop home to RDU. I'm a long-time lurker, first time poster, and first time aircraft owner. I've learned quite a bit since finalizing the sale just this past Wednesday, but...
(Multi-page thread 1 2 3)
20 1,761
GNS 530 for $1000?!?!? Am I Missing Something? by three-eight-hotel
I just saw this link on eBay... http://cgi.ebay.com/NEW-14-28V-GARMIN-GNS530-GNS-530-NAV-GPS_W0QQitemZ7745050682QQcategoryZ63850QQssPageNameZWDVWQQrdZ1QQcmdZViewItem I'm not trying to assist in advertising, but I am wondering what the catch is here. How can a new GNS530 be going for...
(Multi-page thread 1 2)
February 17th 06 02:20 PM
by Gig 601XL Builder Go to last post
17 794
cylinder replacement by [email protected]
Hi, I've owned my airplane, a '69 piper Cherokee, for about 5 years now, and it's finally time that one "annual from hell" that happens to everyone at some point or another to hit. The engine is a lycoming O-360 and currently has around 850 SMOH. It's been overhauled once in it's lifetime. It...
(Multi-page thread 1 2)
February 16th 06 09:03 PM
by Denny Go to last post
12 814
Living in Aluminum by Michelle
Well things are certainly changing around Michelle's household. A contract on dream property in Montana (room for my airplane too), putting my house in Virginia on the market and I have no idea where I am going to be working in a couple of months. To make this a little easier I decided it was time...
(Multi-page thread 1 2 3)
February 15th 06 03:50 AM
by Newps Go to last post
21 872
cylinder replacement by [email protected]
A new cylinder doesn't have to be $1500. New Superiors are under $900 from factorycylinders.com. Thanks for the note. The cylinder shop gave us a quote of around $7000 for four new Superior cylinders. Granted, that does include their labor in inspecting/disassembling the existing cylinders,...
February 14th 06 10:37 PM
by Blanche Go to last post
1 397
Good Cessna 421 Shop by O. Sami Saydjari
I am looking for recommendations of good Cessna 421 Shops in the vicinity of Wisconsin (within a 300 nm radius od KISW would be nice). Does anyone have any positive experiences to share? By "421 shop", I mean a shop that has significant experience maintaining 421's and preferably one where someone...
February 14th 06 10:04 PM
by Brock Boss Go to last post
3 530
Interface my Motorola RAZR phone with the airplane intercom/headset? by Mark Hansen
I'm not sure where to ask this question. Most headsets or intercoms have a way to interface your cellular phone, via the cell phone's headset jack. However, the Motorola RAZR V3 phone doesn't have one - at least not the typical 2.5mm type. It does have a 5-pin mini-USB jack which can be used with...
February 12th 06 03:45 AM
by Greg B Go to last post
1 436
Cessna's next piston single by [email protected]
Has anyone heard any more details about what Cessna is doing for their new piston single? Last I heard, they had confirmed that there is a new plane in the works, but there weren't any details on what it is. I'm guessing they will be showing something at Oshkosh this year. My speculation (which is...
0 433
Hayward Air Race May 18021, 2006 by Gary Waldeck
How good are YOU with a map, E6B and a stopwatch? I don't know if this is of any interest to the group, but the Hayward Air Race is going to be held on May 18-21. It is a graded, precision event much like a road rally, except we do it in airplanes. The event is run in two legs. From Hayward, CA...
February 11th 06 06:52 AM
by Gary Waldeck Go to last post
0 522
Service for PA400 portable intercom by Robert M. Gary
I have a loose connection on my PA400 (the "record in" plug that hooks to my PDA for music). Does anyone have contact information for service on this unit?? I can't seem to find anything in Google. Thanks! -Robert
1 493
KX170B replacement options by Robert M. Gary
I have an odd ball digital replacement 170B that is no longer servicable. Since I already have the 155 and and moving map GPS, I need a basic, inexpensive, nav/com hole filller for it as #3 radio. I really like having it there. What type of used equipment is out there that is a slide-in 170B...
(Multi-page thread 1 2 3)
February 10th 06 12:54 AM
by NW_PILOT Go to last post
24 4,949
What to ask when looking for a plane... by Dico
Hello, As some of you may have concluded with my other posts, we're looking at a getting into a Twin Comanche and I'm curious about what questions to ask after seeing a listing online and prior to getting to the "pre-buy" inspection stage. Currently i'm asking: 1. if all ADs/SBs are complied...
(Multi-page thread 1 2)
February 10th 06 12:16 AM
by Dico Go to last post
10 728
King KX155 question by Kobra
Flyers, I have a Bendix-King KX155 which I use as my primary radio. Lately I have major distortion only on certain frequencies. For example I frequently talk to Atlantic City Approach on 134.25 and the reception is garbled. I have limited data on some things since this is a new problem. But I...
(Multi-page thread 1 2)
February 10th 06 12:04 AM
by Robert M. Gary Go to last post
10 1,621
Did TKM go out of business (maker of MX radios) by Robert M. Gary
I've been trying to get ahold of TKM to ask a question about my MX-170B. Their phone number just goes to voicemail, their fax goes unanswered as does their email. I know they still sell new radios but did the just disappear recently? Does anyone have a better contact for these guys? -Robert
February 9th 06 07:41 PM
by M Go to last post
6 605
New discussion forum for Sport Pilots and Light Sport Aircraft by [email protected]
There is a new easy-to-use discussion forum for Sport Pilots and Light Sport Aircraft. www.SportPilotTalk.com Come join us!
0 687
Tachometer Cable by SAC
Hello everyone, I had a situation where my tachometer cable came loose at the tachometer. I reattched it as tight as I could be hand and is holding so far. I wanted to know if I should try and tighten it more using pliers, or could that cause damage. Or is it common practice to apply something...
February 9th 06 01:38 AM
by zatatime Go to last post
3 614
Post New Thread

Display Options
Showing threads 2001 to 2020 of 5615
Sorted By Sort Order
From The
Forum Tools Search this Forum
Search this Forum :

Advanced Search

New posts New posts More than 15 replies or 150 views Hot thread with new posts
No new posts No new posts More than 15 replies or 150 views Hot thread with no new posts
Closed Thread Thread is closed  
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

All times are GMT +1. The time now is 04:10 PM.

Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
Copyright 2004-2017 AviationBanter.
The comments are property of their posters.