I can't decide. Did this really happen? Or is it doctored? Too much important stuff happens off screen, and the landing doesn't look real.

http://www.avweb.com/blogs/insider/AVwebInsiderBlog_ViralVideo_KillaThrill_LostWingLanding_199096-1.html

Jim Weir..the articles in Kitplanes on subject didn't discuss noise generation from the oscillator cycling output voltage to LEDs. Is there a noise filter requirement to minimize disruption of radio operation?

Anybody has possibility to conact Affordaplane Aircraft? I want to buy their e-plans but I have sent about 10 mails without answer, is there any possibility to telephone them? Tom

Sorry for the google groups. I'm away from home on a laptop sans usenet service.: BWB's obit from the RJ. If you go to the actual site there is a condolence book link. http://www.reviewjournal.com/obituaries/individual_display.jsp?obitID=4638423 WILLIAM PHILLIPS William Grant Phillips, 59, of...

Not joking. Help me out here. -Bob Hoover

Are there any experimental/homebuilt designs that are roughly analogous to the Ercoupe in not needing rudder pedals? I haven't run across any, but that probably just means I'm not doing a good search job.

Hello, I just receive today my new cylinder assy set. I see a plus on the intake port (perhaps 1/8NPT). Original continental cylinders don't have this hole and plug. what may be the fonction of this hole?

TO ALL (!! -- A 'Must Read' for all Engine Builders) It is NOT 'string' it is SILK. More specifically, it is #50 THREAD, although I have seen a German-born, factory-trained mechanic spinning free a few STRANDS from silk embroidery thread. This method applies ONLY to the crankcase's EXTERIOR...

Where are you? I've got a blog. I've posted about 300 entries to it. And a lot of folks have answered back, asking questions. But a lot of them haven't provided me with a return address. In some cases I've posted a reply right in their remarks but often times their requests ask for such a...

I have some questions concerning the Stewart AFS. I'll contact them directly during the week but would like to hear what the group says. Do you know where the STC begins? By that I mean do we need to start with bare metal and use their propriety primer, or will zinc oxide or 2 part primer work...

other than for medical purposes has anyone seen powdered zinc oxide that could be mixed with a second agent to produce a specific quantity of zinc oxide liquid (which could then be sprayed or painted on)? - Mike

How is Janice mending? Stealth Pilot

is it reasonable to assume that if presented with a choice of grit sizes (20.40.80), that 80 would be the finest? like sandpaper roughness - Mike

He even mentioned a good friend of mine, Gil Armbruster, who also perished flying his homebuilt Revolution Mini500. http://groups.google.com/group/rec.aviation.rotorcraft/msg/56e21d4e4f21379d RIP Bill, Monk

To All: Wish me luck. Going under the knife in about two hours. -R.S.Hoover -@ 0615

I caught an article by Jim Wier in Nov.'s Kitplane Mag. Good article Jim. Monk

http://www.chilloutzone.de/files/08102703.html

My all time favorite was Badwater Bill's University for Women http://groups.google.com/group/rec.aviation.homebuilt/browse_thread/thread/e17b38b856244c4a/6ead7c7d675869a0?lnk=st&q=%22for+women%22+author%3Abadwater+ bill#6ead7c7d675869a0

I did know Bill personally and always found him a facinating character. Every time I did post to rah Bill would always simply reply " I thought you was dead" I'll really miss him. Ed Sullivan