|
|
Can't rekey locks? Where to order by #?\ by
Ben Jackson
I called a locksmith who said that disc tumbler locks were not made
to be disassembled an re-keyed. My goal is still to match the door/
baggage locks to the mag switch (they're all the same family of key).
Is there somewhere I can order replacements for the door/baggage by
the key number of the...
|
May 17th 05 02:05 AM
by DHead
|
2 |
770 |
|
|
Does anyone recognise this part? by
kurtyboy
I am trying to find out what this part is. Does anyone recognise it? If not this exact model then can you tell me what it actually is?
Thanks...
|
|
2 |
2,097 |
|
|
Still C85 Nose Leak by
Dick[_1_]
Previously this list advised a split seal is used on my flanged crank C85
and I then verified my case vent, hoses and air/oil separator system were
not blocked.
Since rather than pulling that spinner, prop, nosecone and cowl baffling to
install a new crank seal, would like to ensure I'm not...
|
|
2 |
1,661 |
|
|
Changing LC2 Battery by
Steve - KDMW
I need to change the battery in my Astrotech LC2 clock. I've never
done this before and I can't find anything about it on line. Do I have
to pull the whole darn thing out to change the battery?
Steve
PA28-151
KDMW
|
|
2 |
1,266 |
|
|
|
|
2 |
456 |
|
|
|
October 16th 06 05:35 PM
by Michael
|
2 |
598 |
|
|
Buyers market! Vref and NAAA by
wise purchaser
Greetings!!!
Buyers market now!!!! DON'T pay over Vref or NAAA for your airplane
purchase! HOLD tight! HOLD TIGHT!!!
If you pay to much, When you go to sell the 'creampuff' that you
had to sink thousands of $$$$ finding out that it was a flying clap
trap YOU are going to be the one...
|
October 10th 06 05:10 PM
by Newps
|
2 |
604 |
|
|
Free entertainment purchasing an airplane! by
wise purchaser
Greetings!
I have been looking to purchase an airplane and have noticed a side
note during the search : Entertainment!
When I talk to some perspective seller, as they tell me about thier
'creampuff' airplane I am at the SAME time loading the DATA of thier
airplane into Vref or the NAAA ...
|
|
2 |
535 |
|
|
Osh Photo's by
Don Parsons
www.fairchild24.com/osh06.htm
|
|
2 |
627 |
|
|
Hangar space near Norman, OK? by
SteveR
I'm going to be moving to Norman, Oklahoma in a few weeks, and need a place to hangar my Pietenpol. It seems that Westheimer (KOUN) is pretty full, and Perry (1K4) only seems to have open hangars available. Can anyone direct me towards some hangar space? Grass strips are fine, as are small...
|
|
2 |
771 |
|
|
Hanger space S. Florida by
smf
I'm relocation to S. Florida (Hollywood) area. I'm need hanger space for a
composite airplane Any info would be appreciated.
Thanks
Steve
|
September 13th 04 05:15 AM
by RH
|
2 |
836 |
|
|
LoPresti Fury by
Dude
Is there any new news on the Fury at Sun n Fun or otherwise?
With the few times I put anyone in the backseat, I am thinking it might be a
good next plane for me.
|
April 18th 05 07:48 PM
by Oski3
|
2 |
636 |
|
|
Tach Generator Cessna 340 by
[email protected]
My RPM gauge does not show anything at startup on right engine. Then at
runup it comes to life at high RPM. Then after that it works fine. It
wobbles a bit sometimes in the air. My take is that my tach generator
is the problem. Any other ideas. Also do you know where to get a
replacement unit or...
|
March 29th 05 04:31 PM
by Allen
|
2 |
570 |
|
|
PA28 140 starter removal by
George Hamilton
Can someone tell me if I can remove the starter from 0 320 Lyc without
taking the prop off. Starter is old an has been acting up for some
time. Needs new brushes for certain.
|
|
2 |
840 |
|
|
Repairing Fiberglass Wheel Pants -- Results by
Jay Honeck
Okay, here's the final tale of the tape:
(These are GPS ground speeds, verified either in absolutely calm air or in
two directions. Probably not a 100% perfect method, but close...)
Without fancy pants: 136 knots at 23 squared.
With repaired fancy pants: 143 knots at 23 squared.
This is a 5%...
|
|
2 |
1,280 |
|
|
Grumann Cheetah by
bill
I am looking for a lower cowling for my Grumann Cheetah. Does anyone
have any suggestions where I can find one, preferably used. Thanks,
NM
|
|
2 |
874 |
|
|
Hangar for rent. KMMV Oregon by
broadmead
Just wanted everybody to know that I have a 40' x 30'+- "T" hangar for rent.
It is at the Mcminnville Oregon airport and costs $250 per month. It is a
new unit that includes basic electricity.
Protect your baby from the upcoming winter; available now..
Contact John...
|
|
2 |
1,301 |
|
|
Reinstalling vacuum DG by
Mike Noel
I finally pulled my Mitchell (Edo-Aire?) vacuum DG and sent it off to
Bernard Ducasse for overhaul. For those following the new vs. re-new
debate, I'll let the group know how the overhaul turns out.
After removing the DG, I covered the exposed ends of the vacuum hoses left
dangling in the plane...
|
|
2 |
477 |
|
|
Mooney Electrical Systems by
Jon Kraus
Would a '79 Mooney M20J have a 14 or 28 volt electrical system? I am
thinking about buying one and wanted to look at some avionics. Thanks!!
Jon Kraus
PP-ASEL-IA
Student Mooney Purchaser
|
|
2 |
787 |
|
|
King Comm by
Tom Cummings
Will the King KY 197 Comm unit fit into the tray for the King KY 97 Comm
unit as a slide in replacement?
Thanks,
Tom
|
|
2 |
1,191 |