A aviation & planes forum. AviationBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » AviationBanter forum » rec.aviation newsgroups
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Post New Thread
Threads in Forum : Owning Forum Tools Search this Forum Feed Icon
  Thread Reverse Sort Order / Thread Starter Last Post Replies Views
OT Airshow in Jackson MS - Video by A Lieberma[_2_]
Airshow in Jackson MS - Video Ear plugs optional when viewing :-) First time I have ever been to an airshow of this magnitude. I was there only three hours of the 7 hour show and the following videos are highlights of what I had seen. http://www.youtube.com/watch?v=Zx-KugHZ3gY (non jet...
October 4th 09 05:35 PM
by A Lieberma[_2_] Go to last post
0 2,227
OT Dr. Strangelove by [email protected]
Anyone know what the Slim Pickins quote "I'm gonna get them doors open if it harelips everybody on ear Creek!" means. I have just watched the movie (again) and have always wondered it it has any hidden significance. Regards, Jerry
October 5th 06 12:39 AM
by [email protected] Go to last post
0 461
OT Dr. Strangelove by [email protected]
I have just watched Dr. Strangelove (again) and have always wondered if the Slim Pickens quote "I will get them doors open if it harelips everybody on Bear Creek!" has any meaning other than the dialog. Any ideas? Regards, Jerry
October 5th 06 04:15 AM
by houstondan Go to last post
4 1,940
OT T6 Flight to Greenwood MS with Aerobatics enroute - Video by A Lieberma[_2_]
T6 Flight to Greenwood MS with Aerobatics enroute - Video http://www.youtube.com/watch?v=5ami-dqDiRk Flight in a T6 including barrel roll, aileron roll, loop and hammer head stall while enroute to Greenwood MS. Video is only a taste of what I experienced yesterday. More videos will be forth...
September 9th 09 02:25 AM
by A Lieberma[_2_] Go to last post
0 1,549
OT T6 Formation Flight Randoms - Video by A Lieberma[_2_]
Last allotment of my T6 videos. Kinda saved the best for last. http://www.youtube.com/watch?v=Rc2cua16euk The focus of this video is the tightness of the formations and the precision All shots were with the camera were zoomed out and as you can see I could barely get one plane in the picture,...
September 12th 09 08:20 PM
by Orval Fairbairn[_2_] Go to last post
3 2,020
OT T6 Formation flight with Ship to Ship and ATC COMS - Video by A Lieberma[_2_]
T6 4 ship formation flight over Greenwood MS. http://www.youtube.com/watch?v=B96gfcxci60 Video starts from Engine startup and includes the following formatons: Trail, Finger Four, Echelon and Diamond Formations. A couple of joins and breaks included for good measure. Additional details about...
September 10th 09 12:47 AM
by A Lieberma[_2_] Go to last post
0 2,523
OT-San Antonio Lodging by Terry
As a member of this newsgroup for many years, I thought this would be a good place to get advice from my fellow pilots. My son is leaving for Afghanistan on the 21st of Aug from Camp Bullis. I am looking for a place to stay from Aug 20th - 22nd. Would like it to be near the "River Walk" area so...
July 27th 09 07:02 PM
by Mike Go to last post
1 1,393
OT-Sorta Garmin 296 Auto Nav Kit by Terry
I've used my Garmin 296 in the airplane for several years now and love it. In the Automotive Mode, it will show major interstate highways etc but want more detail in the major cities. I would like to buy the "Auto Navigation Kit" from Garmin that contains the 128mb data card, City Navigator CD...
August 2nd 06 12:40 AM
by Kobra Go to last post
4 984
Other than JPI, who else is there? by Jim Carter[_1_]
Other than the JPI EDM line of engine analyzers, what other manufacturers are out there with good, reliable, full featured products for a big bore Continental? ----------------------------------------- Kindest regards, James A. (Jim) Carter, ANS #8215 Rogers, Arkansas
(Multi-page thread 1 2)
September 24th 07 11:39 PM
by Ray Andraka Go to last post
19 1,075
otis winslow by bryan chaisone
"OtisWinslow" wrote in message # No hoax. These foreigners are streaming into our country for the # purpose of taking us over. Arm up and buy ammo while you can. # Shootouts with them are going to be common place. # OK Otis, Sheriff Andy Taylor and Barney Fife's got...
November 26th 04 08:20 PM
by bryan chaisone Go to last post
0 741
Ottawa Tie-down by Jose Vivanco
I'm in the process of moving from Montreal to Ottawa and I'm looking for a tie-down for my Cherokee 140. I will also need access to a good mechanic. So far I've only heard about the Ottawa Flying Club. Any words of wisdon on both subjects would be much appreciated. Thanks Jose Vivanco C-GPYH
(Multi-page thread 1 2)
October 10th 03 08:34 PM
by Andrew Boyd Go to last post
18 1,351
Out of annual.... by A Lieberman
and back in the saddle, but not without a little excitement *smile*. 30 hours later, $1,700 less in my wallet and new wheel bearings to show for it, I decided to take a short hop from KMBO (Madison, MS) to KJAN (Jackson MS) which was a whole 9 NM to pick up a passenger who was coming in on...
October 31st 05 02:47 AM
by Dave Go to last post
7 793
Out-of-calibration transponder operation by Jim Stewart
I was thumbing through the FAR/AIM last night, trying to fall asleep and I noticed something that I couldn't understand. It appeared (in my half-asleep state) that the FAR says not to operate an out-of-calibration transponder at all, and the FAR says to operate it with altitude reporting off. On...
(Multi-page thread 1 2)
September 19th 07 02:06 AM
by Ray Andraka Go to last post
11 761
Outlandish Particle Periodic Table update IX by Tony Lance[_7_]
Big Bertha Thing outlandish OUTLANDISH PARTICLE PERIODIC TABLE By Tony Lance Dip.Math(Open) 19th December 2009 Update IX from http://www.tonylance.talktalk.net/structur.html .510998902 1.0D-09 1 1 80305 1 3224486665 1.0 SLC For full table see link:-
December 28th 09 03:58 PM
by Tony Lance[_7_] Go to last post
0 2,212
Outlandish Particle Periodic Table update IX by Tony Lance[_8_]
Hi there, Salient features:- Cern list of 900 experimental particle results in MeV, double precision and mathematical (Fortran 77) The list alone is not available anywhere-else, as a single list. Not definitive. 42 year scientific project, by ex-Mensa member. (They stopped concessionary...
April 17th 10 02:10 AM
by brian whatcott Go to last post
7 2,396
Outrageous City Hangar Rule by Jon Woellhaf
Last week, my name finally rose to the top of the shade hangar list at South Valley Regional Airport (U42) in West Jordan, Utah. U42 is a few miles south of Salt Lake International (KSLC). When we went to see the airport manager to sign the contract and get our badges, he told us an interesting...
May 21st 10 11:27 AM
by Bob Noel[_6_] Go to last post
1 2,445
Outside air temperature probe by dlevy
I had a new windshield installed and don't want to drill a hole in the new windshield for the old temperature probe. Is there a cheap alternative that I won't have to drill the windshield to install?
November 7th 06 05:14 PM
by Newps Go to last post
9 1,027
Overhaul !!!!! ?????? by Charles Talleyrand
My local mechanic says that I need to overhaul my engine. It's got 1200 hours but it's been 27 years since the last overhaul. He's worried about the age, and he hears "piston slap" when he runs the engine. Compression and oil analysis are fine. He is well respected around the local airport. He...
October 4th 08 05:56 PM
by Orval Fairbairn[_2_] Go to last post
8 1,277
Overhaul 14 year old prop? by Jay Honeck
Our constant speed prop is getting long in the tooth. It was last overhauled in 1991, when it received new blades. My A&P says there is no reason to O/H or replace a prop so long as it meets specs and doesn't leak. Since we fly a couple of times per week, internal corrosion shouldn't be an...
(Multi-page thread 1 2 3 ... Last Page)
September 28th 05 04:27 PM
by Jim Burns Go to last post
34 1,832
Overhaul information by Jerry Jesion
I was wondering exactly which parts are generaly NOT replaced in an engine overhaul. Assume all new cylinders/pistons/rings/pushrods. I know that the crank is often not replaced if it checks to spec, and the cam may be reground and replaced but what about other parts? Are the con rods usually...
September 1st 04 01:12 AM
by JDupre5762 Go to last post
1 350
Post New Thread


Display Options
Showing threads 3501 to 3520 of 5626
Sorted By Sort Order
From The
Forum Tools Search this Forum
Search this Forum :

Advanced Search

New posts New posts More than 15 replies or 150 views Hot thread with new posts
No new posts No new posts More than 15 replies or 150 views Hot thread with no new posts
Closed Thread Thread is closed  
 
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT +1. The time now is 11:04 AM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 AviationBanter.
The comments are property of their posters.