A aviation & planes forum. AviationBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » AviationBanter forum » rec.aviation newsgroups
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Post New Thread
Threads in Forum : Home Built Forum Tools Search this Forum Feed Icon
  Thread / Thread Starter Last Post Reverse Sort Order Replies Views
ESA Eastern Workshop by Wayne Paul
After a very successful Workshop last year, the Eastern region of the Experimental Soaring Association (ESA) (http://www.esoaring.com/ formerly know as the Sailplane Homebuilders Association) is planning to hold its, Workshop again this year at Chilhowee Gliderport (http://www.chilhowee.com/),...
March 12th 07 01:27 AM
by Wayne Paul Go to last post
0 778
Inverted oil cooler mounting by [email protected]
Folks-- I have a bit of a clearance problem for my oil cooler. As is usual, I can either mount it where it gets good air flow or I can mount it where fits nicely--but of course, not both. I am opting for the good air flow for all the obvious reasons. Part of what makes this location tricky is...
March 11th 07 01:40 AM
by stol Go to last post
2 1,070
Who Is in Control of China's Aircraft Carriers? by Sound
http://en.epochtimes.com/news/7-3-9/52602.html When the U.S. dispatched two aircraft carrier fleets in the spring of 1996 for cruising in the vicinity of the Taiwan Strait, China quickly ended its military maneuvers that were intended to threaten Taiwan's presidential election. China's...
March 10th 07 08:48 PM
by Paul Tomblin Go to last post
2 1,801
2nd RFD: remove rec.aviation.announce moderated (LAST CALL FOR COMMENTS) by Jim Riley
An RFD/Last Call for Comments regarding the removal of rec.aviation.announce has been posted in article If you wish to discuss this removal, please direct your comments to news.groups.proposals. Note that the removal of rec.aviation.announce will...
March 10th 07 10:38 AM
by Jim Riley Go to last post
0 771
2nd RFD: remove rec.aviation.answers moderated (LAST CALL FOR COMMENTS) by Jim Riley
An RFD/Last Call for Comments regarding the removal of rec.aviation.answers has been posted in article If you wish to discuss this removal, please direct your comments to news.groups.proposals. Note that the removal of rec.aviation.answers will have...
March 10th 07 10:30 AM
by Jim Riley Go to last post
0 901
Calendar scans by Aerowolf35
Anyone have scans of the pictures in any of the Tantalizing Takeoffs calendars? Please contact me at Thanks Edwin
March 8th 07 11:32 PM
by Lou Go to last post
2 1,014
6005-T5 spar extrusion by jeanch
Hello, Does anybody have knowledge about using aluminum alloy 6005-T5 for a wing spar extrusion in replacement of 6061-T6 ? Apparently it has the same properties and is more extrudable. I am concerned by the "same properties", especially fatigue; but cannot find anything on the subject and I am...
March 8th 07 10:09 PM
by jeanch Go to last post
3 2,019
Vision Microsystem being killed by JPI? by Scott Derrick
I placed an order for a 6 cylinder VM1000C last July. I didn't realize that JPI was buying Vision at that time. I was told to expect it in 2 months, which was OK. In 2.5 months when I hadn't heard a word I called and got a message to call a number in Texas? I called that number and was...
March 7th 07 03:56 PM
by jls Go to last post
2 759
Questions on installing an intercom by [email protected]
I have an electrical/audio question. The intercom I'm installing has a wiring diagram that shows the sleeve terminal of the phones and mic connected to the shield at the radio end. This seems pretty typical. My question: is it okay practice to use the wiring shield as one of the conductors? In...
March 5th 07 04:14 PM
by [email protected] Go to last post
2 494
Variable intake/Exhaust Ducts for Ducted fans. by EridanMan
Hey Guys, I know that ducted fans are somewhat the sophomoric siren of amateur aircraft design... Such tantalizing performance benefits (No PSRU/ higher fan/prop speeds, much better control of thrust airfoil environment, greater propulsion mass for small fan diameter, etc) only problem is, they...
March 4th 07 04:50 PM
by Roberto Waltman Go to last post
2 651
Transponder antenna radiation by [email protected]
My transponder installation instructions suggest to place the antenna over 6 feet away from human body to keep the radiation away. I have a composite fuselage and use an aluminum disc with the standard quarter wave antenna. If I place the antenna and disc below me so the antenna is on the side of...
March 4th 07 04:13 PM
by [email protected] Go to last post
0 563
Transponder andtenna radiation by [email protected]
My transponder installation instructions suggest to place the antenna over 6 feet away from human body to keep the radiation away. I have a composite fuselage and use an aluminum disc with the standard quarter wave antenna. If I place the antenna and disc below me so the antenna is on the side of...
March 4th 07 04:08 PM
by [email protected] Go to last post
0 576
Sealant for polyethylene fuel tank? by TerryJ
Teflon tape from ACE hardware.... +ACI-Rob Turk+ACI- +ADw-wipe+AF8-this+AF8-r.turk+AEA-chello.nl+AD4- wrote in message news:16cac+ACQ-45e67888+ACQ-3ec2f251+ACQ-13222+AEA-news.chello.nl... +AD4- I'm looking for a sealant or kit to seal brass NPT inserts into a +AD4- polyethylene tank. This is a...
March 3rd 07 04:10 AM
by TerryJ Go to last post
0 520
RST Digital Engine Monitor-ATTN Jim Weir by dodger
I'm attempting to build the RST Digital Engine Monitor (Kitplanes Feb. 2002). I could not find the LCD panel meter specified in the plans or even the substitute mentioned in the addendum (http://www.rst-engr.com/ kitplanes/KP0202/KP0202.htm) so I tried to substitute one I found at All Electronics...
March 3rd 07 02:22 AM
by dodger Go to last post
6 1,196
First-hand video of a BRS deployment. by Jim Logajan
I got the following link to this video via the Matronics Zenith e-mail list. What's interesting and fascinating about it is that it contains video from a cockpit camera that shows the impending mid-air collision and the cockpit view when the aircraft hits the ground under the...
(Multi-page thread 1 2 3 ... Last Page)
March 2nd 07 10:15 PM
by Whome? Go to last post
166 9,137
Revolution Mini 500 - is it buildable? by Jim Anglin
I have an opportunity to bring home a Mini 500 kit for no money or at the least a couple thousand dollars. As far as I can tell it is all there and has never been touched by the original purchaser. I have poked around in cyberspace and learned a little about this airplane, some of which is not...
(Multi-page thread 1 2 3 ... Last Page)
March 2nd 07 06:59 AM
by Roger[_4_] Go to last post
54 3,354
Jacksonville Law by Jerry Springer
http://www.eaa.org/communications/eaanews/070228_jacksonville.html
March 2nd 07 04:11 AM
by Morgans[_2_] Go to last post
2 730
Welding 4130... by Blueskies
I am a rookie at this welding stuff, and plan to get plenty of practice before building real airplane parts. That said, what do you all think about heat treating after welding? I will be gas welding. Do I really need 4130 rod, or can I use another high carbon steel rod? How about 'S2' rod (only...
(Multi-page thread 1 2 3)
March 1st 07 02:33 AM
by Maxwell Go to last post
20 1,336
Cylinders and corosion by Philippe Vessaire
Hello, What are the best corosion resistant cylinder for O200 engine? genuine TCM ECI-Titan Millennium Cylinders from Superior airparts. any other I don't know... Thanks
March 1st 07 12:42 AM
by [email protected] Go to last post
6 1,175
Looking for twin-tail design info by Patrick
Hello, I am looking for books, papers etc. on twin-tail (h-tail) design considerations. Ercoupe, B-25 etc. vs. conventional tail and so on. If anyone knows where I can find information like this, please let me know. Thanks!
February 28th 07 06:12 AM
by [email protected] Go to last post
1 726
Post New Thread


Display Options
Showing threads 1881 to 1900 of 6903
Sorted By Sort Order
From The
Forum Tools Search this Forum
Search this Forum :

Advanced Search

New posts New posts More than 15 replies or 150 views Hot thread with new posts
No new posts No new posts More than 15 replies or 150 views Hot thread with no new posts
Closed Thread Thread is closed  
 
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT +1. The time now is 11:13 AM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 AviationBanter.
The comments are property of their posters.