The glare shield in our 64 Skyhawk is original, therefore not the most pristine to look at. Is there a cover available, such as the carpet covers you see for autos/trucks, available for airplanes? Yes, I know I can get a $200+ plastic cover rom Selkirk or others that covers the entire glare...

I have a C-172B that has the dual landing lights in the wing. The first position on the pull-out light switch turns on only the taxi light (at least I assume it is for taxi as it is aimed so low) and the next position turns on both (landing and taxi). Does anyone know if there is a legal...

I had asked if anyone knew of a replacement Cessna landing light switch that would turn on the taxi light and landing light separately (not both on the second pull-out notch so as to ease the electrical load during low RPM). I had given up and was going to take Denny's advice to remove the existing...

According to AvWeb, Cessna says they are going to have a hard time producing their LSA for under $100,000. That's not going to sell well. Then again, I may be wrong!

Cessna is rationing their LSA very strictly. Each dealer gets exactly one! If you want a Cessna LSA you AND your dealer, apparently, have to go to Oshkosh with a $10,000 deposit one week before the show and meet with a Cessna representative. There are no hotel rooms available and Cessna will...

I've exhausted all my sources for a Cessna muffler shroud without paying through the nose to Cessna itself. Cessna 182A used a muffler 0750130-12 with a shroud 07501030-13. My shroud is pretty much toast, especially considering how it got thrashed about in our little difficulty in Wyoming last...

Cessna N734AE VFR Flight with ATC COMS - Video Me acting like a noob as a passenger on todays VFR flight to Brookhaven MS. http://www.youtube.com/watch?v=pjmjttvrRN8 An exclusive video probably not to be seen anywhere else on You Tube (that is an aerial shot of the snow cover) The squeals of...

Cessna was the high bidder for the assets of Columbia aircraft. They will keep the plant open and rebadge the aircraft as the Cessna 350 and 400. Cessna will also apparently keep their NGP concept aircraft in process with a long term goal of replacing the current high wing series with a new...

I am looking for heavy-duty seals to replace standard o-rings in cessna single engine nose strut.Collapsing and leaking problems...I have heard about cold weather seal and square-ring but I'm still searching for P/N and specs. THANKS

In the Cessna 172's nosewheel strut are several O-rings, but the one that seals against the chrome piston sometimes twists in its groove and a spiral failure (tear) occurs. All the outer-cavity oil escapes, then the nitrogen leaves and the strut goes flat. The failure appears to happen rather...

We have a plane in our club (1978-ish C172N) that has a problem with the pilot's push to talk switch. It is mounted on the yoke handle (as if from the factory, not like an after market). When you press it gently, it works fine. If you press it too hard, the radio continues to send the carrier, but...

May I refer you to: http://www.kjsl.com/~javier/sb-1.pdf http://www.kjsl.com/~javier/sb-2.pdf http://www.kjsl.com/~javier/ad-1.pdf http://www.kjsl.com/~javier/ad-2.pdf That deals with the seat rails on Cessna single engine aircraft. It's pretty straightforward, when the holes on the rails are...

Hi, We just had our annual done on our 172E, and there were cracks found in the forward horizontal stabilizer spar. The remedy is to apply Cessna Service Bulletin SEB94-8. Does anyone know where I can obtain a copy of this bulletin online? I'm trying to get an idea of the cost of this...

Great condition: http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=2462879394

Does anyone know anything about the "Riley Rocket" version of the Cessna Turbo 310? I am getting claims of "260 KTAS at 20,000 feet burning only 24 gph total." Does that make sense? Seems a little too good to be true. Does anyone have actual experience with a Riley Rocket that matches this...

I need to repair the stock Cessna wheelpants for my 1973 Skyhawk. Splits, freyed edges, scrapes, etc. What is the proper type of cloth and resin to use? Thanks, Tom Cummings

I just saw an ad for a reproduction window latch. Now I can't find it when needed. Does anyone remember who is making them? Best, Karl "Curator" N185KG

A couple of A&P and IA buddies of mine and I have been discussing wing rebuilding possibilities. Does anyone have plans or know where to obtain plans for a Cessna wing jig? Are there jigs available for rent or sale near Wichita? The wings we are interested in are for 150, 152, 172, 175, and...

Does anyone have plans or know where to obtain plans for a Cessna wing jig? How much is an old jig worth (factory or fabricated)?

My Cessna 172 M (1973) is being annualed. The top wing skin panels above the wing tanks (Standard tanks) have to come off to inspect the area for corrosion. We got all the screws removed. According to the service manual, that is all that is supposed to be securing the panel. (Dozens of...