Thread
:
Source for copper crush gaskets???
View Single Post
#
1
August 22nd 03, 06:31 PM
Jim
external usenet poster
Posts: n/a
Source for copper crush gaskets???
You may mean .0625"
"Rex B" wrote in message
...
On 22 Aug 2003 14:42:41 GMT,
wrote:
|Hi groups.
|
|I'm looking for a source for copper "crush" gaskets for an intake to head
|application in vintage cars. All my usual sources come up dry. A search
|on the web for "copper crush gasket" yeilds a lot of air craft supplier
|sites, so I'm taking the liberty of cross posting to a few that deja.com
|(google) hit on the same search. The ring I need is OD 1.125", ID .875"
|and thickness about .625". OD is the most important, could fudge on the
|other dimensions a bit. Any ideas? Need a quantity of 20 or so, but
|would happliy buy a larger pack if needed.
|
|Also, some of the originals looked to be alumimun, that would work also.
|It is not a terrbily high heat application and vibration/stress is
|probably pretty low.
John
Post to rec.crafts.metalworking.
If they don't know of a source I bet someone will offer to make you a few.
Did you try MSC?
Rex in Fort Worth
Jim