Thread
:
Surface radiators for water cooled engines
View Single Post
#
52
July 12th 03, 03:57 PM
Jay
external usenet poster
Posts: n/a
(Bob Kuykendall) wrote in message
If you think you have a good idea, then fine, try it. Make a
prototype, test it under representative conditions, and publish your
results. If the results bear out your assertions, you will be hailed
as an insightful genius. If there are competitive advantages to your
idea, you can expect to see swift application of it to a wide variety
of heat exchange situations.
I think its too soon make that step, I'm not sure what the proportions
need to be.
Anyhow, yammering about your idea here on Usenet accomplishes less
than zero, since it takes up time that you could otherwise be using to
implement and test your idea. From the fact that you persist in
arguing about it in this forum, I can only conclude that you are more
interested in the argument that in the idea under discussion.
"Listen, I'm not here for an argument..." (Python)
I didn't come to the newsgroup to as advice. The idea was to have a 2
way discussion, I guess you could call that yammering. Sometimes in
the early stages of a development you just brain storm and bounce
ideas off different people's heads. Its a fun excercise for people
who like to think and interact. Its true, the CNC isn't chewing
aluminum and there aren't any flames yet, so it isn't quiet as
exciting, but until you think you've got the theory understood, you're
wasting time and material trying to construct something that will
likely take an inordinate amount of experimentation to optimize.
Thats the difference between an engineer and a tech I guess.
And that's a shame, since your surface radiator idea would be pretty
easy to prototype. All you need is an old pickup truck, an old car
hood, a bunch of copper tubing, a bunch of cheap plumber's solder, and
a propane torch. Oh, and a driver's license...
You need a propeller and cowl as well. The success of the idea may
hinge on the turbulence in the prop wash which decays very quickly as
you get further from the prop blade.
I mean, I think it's a dead-end idea, but I'm prepared to be
demonstrated wrong. But if you persist in just telling folks that
they're wrong without a shred of either empirical evidence or
engineering support, you're gonna stay pigeonholed in a lot of folks'
chucklehead files.
In a discussion its okay to disagree with someone as long as you can
supply a reason. The other person, can then attempt to address that
issue. This goes on and on until you've either come to the same
conclusion or some fundamental point on which there is a disagreement
which must be settled by experimental data or a more detailed off-line
analysis.
Thanks, and best regards to all
Bob K.
http://www.hpaircraft.com
Jay