"George Patterson" wrote in message
...


Allen wrote:

You may want to check with your mechanic about this also. I think the
proper
way to check torque of a bolt is to loosen it first and then re-torque.

Nope. Just buy a modern wrench, set it to the bottom end of the proper
torque
range, and try to tighten the bolt. If the wrench "clicks" without the
bolt
turning, you're good to go. If the bolt turns first, call that to the
attention
of your mechanic.

George Patterson
He who would distinguish what is true from what is false must have an
adequate understanding of truth and falsehood.

That will only tell you if the bolt is under-torqued. To make sure it is
torqued to a specific number it must be loosened first.

Allen