Rick Durden wrote:
Otherwise, the only reason to enrichen the mixture during descent is
if the engine actually begins to run roughly. (See the POH which only
recommends enrichening if you experience engine roughness.) Most
people descend at 65% power or less, which means that it is impossible
to detonate the engine due to lack of heat and pressure, so it's
impossible to run it too lean (it will simply start to run rough and
then quit if you get it too lean, you won't hurt anything). Keeping
it leaned during descent helps avoid overcooling (if you believe in
shock cooling), helps keep the plugs from fouling and doesn't waste
fuel. In general, once you lean the engine for cruise on a T182 you
needn't touch the mixture control until you pull it to idle cutoff
after landing, or to go to full rich on a go around.

All the best,
Rick

The POH for my TB-21 (turbocharged Trinidad) with a
Lycoming TIO-540 calls for putting the mixture full rich
prior to landing. Is that different from what most people
do with this engine?

--
David Rind