"Lisa" wrote in message ...
Perhaps this doesn't matter much for a non-turbocharged engine,
but an instructor says that it is best to idle the engine at
1,000 RPM for a few moments before Mixtu Idle Cut-Off at that
RPM to shut down.

I doubt 1000 RPM is an idle setting for most piston aircraft engines.
Probably best to avoid confusing the issue by not using the word "idle" when
you don't really mean having the throttle set to idle.

With that out of the way, I don't see any compelling reason to run a
non-turbo engine prior to shutdown. I suppose that if you also lean the
mixture, you might get rid of some plug fouling, but if you're having
trouble with plug fouling, you can better address the issue operationally by
making sure the engine is leaned during taxi.

Obviously, with a turbocharger, allowing the engine to run prior to shutdown
is a good way to help circulate engine oil through the turbo and allow it to
cool down more gradually, and without cooking the oil. AFAIK, whether you
do this at 1000 RPM or at idle is less important than whether you do it at
all.

But with a non-turbo engine, I don't see why idling or running the engine at
1000 RPM would be beneficial, as a general rule of thumb (allowing for the
possibility of some particular instance where it might be useful).

What reason does this instructor to which you refer give for running the
engine at 1000 RPM prior to shutdown? Also, what does "a few moments" mean?
To me, that's less than five seconds, which I can't imagine would make a
difference in any case.

Pete