Two part answer. First, runways with single-digit designators (1,2,3, etc)
do not have a preceding zero painted on them. Second, FAA-P-8740-47 "Radio
Communications Procedures and Techniques," which hardly anyone has or has
read, says that if there is more than one digit, each digit should be
spoken, as in "one three" rather than "thirteen." If there is only one
digit, there is no reason to enunciate two digits.

However, don't be surprised to hear a controller say "Climb and maintain one
one thousand, eleven thousand" because there have been some
readback/hearback problems with pure digits.

Bob Gardner

"Tony Cox" wrote in message
ink.net...
I've had a smoldering dispute with a CFI friend of mine for
years about whether to announce (say) "zero-two" or just
"two" when operating at an uncontrolled field with runways
2-20. My friend is of the opinion that the extra "zero" is
superfluous, whereas I've always instinctively said "zero-two"
without really understanding why I do it. It has always "just
seemed right", with a blank in the orderly transmission of
information that cried out to be filled.

This weekend I felt vindicated. As I started to taxi out at
0L7 (two runways, 2-20R and 2-20L), I was not particularly
surprised to hear a Cherokee doing touch-and-gos on runway 2 (the
wind was 5 out of the north). Listening to several calls as I
prepared to depart, I finally caught a "two-zero" -- the fellow,
out of exuberance or lack of currency was letting his finger
slip off the transmit button to give an entirely erroneous and
completely believable false impression of what he was up to.
Turns out he was practicing downwind landings. Add to that
that the airport is right traffic for 20 and left for 02, the potential
for disaster is evident.

So what do instructors teach these days? Do you add the
extra zero or not?

--
Dr. Tony Cox
Citrus Controls Inc.
e-mail:
http://CitrusControls.com/