Bill, I just finished doing mine and right after you
putin the unit ID on the web page and continue, garmin
then put through the web page that has Password, unlock
code and order #, they also sent a e-mail to the address
email I put in at the beginnining. But don't continue
with the program for you GPS until you have the unlock
code! Hope this helps.

Cliff


At 23:54 15 October 2003, Bill Daniels wrote:
I ran it from the top again and it still wants an unlock
code.

Bill Daniels

'Eric Greenwell' wrote in message
. ..
In article ,
says...
I tried this with my Garmin 90 and got a far as downloading
the database
and
connecting my PC to the GPS90 but the install procedure
demanded a
'update
code' which, of course, I didn't have. I can't find
any way to get an
update code. I've e-mailed the support people at
Garmin but no response
yet.

I was able to do it without a problem, just by following
the
instructions. After running the downloaded update
program (with the
GPS90 connected, of course) and getting my unit code,
I pasted the
unit code into the requested spot. Continuing from
there, the website
came back with the required info, allowing the update
program to
continue.


--
!Replace DECIMAL.POINT in my e-mail address with just
a . to reply
directly

Eric Greenwell
Richland, WA (USA)