"Todd Pattist" wrote in message
...
"tango4" wrote:

On an aircraft like the ventus there are several sections of control
surface
along the T/E of the wing resulting in several 'breaks' in the trailing
edge.

My Ventus C has those breaks covered with flexible
semi-permanent tape.
Todd Pattist - "WH" Ventus C
(Remove DONTSPAMME from address to email reply.)

I'm not a Ventus owner but a Nimbus 2C owner and I'm following this closely.

Todd, are you talking about the flap and aileron hinge gaps? I think the
question was about the end to end gaps between the each flap section and
between the outer flap and aileron when the flaps are deflected.

Bill Daniels