I'm using either Downloader via an IPAQ or LXE with a laptop to move
information so I don't know much about the Winpilot interface.
However, the Winpilot uses the same NMEA data stream As Fly With CE.
The settings can be found under the setup menu. That is accessible
through the menus behind Password.

The NMEA stream goes through the 232. The LX7K had a cable set
labeled Winpilot which hooked into the dangling 232 cable. I think
the only purpose it served was a wiring reconfiguration to support
IPAQ communication.

The round shaped 5 pin I connect to a female terminated cable to a 232
serial to the laptop. I've never checked to see if the NMEA data goes
to this port.



"Ludovic Launer" wrote in message ...
Thanks a lot.
Where are NMEA sentences coming out from ?
From the RS232C ? or from the PC-RS232C ?
Or both maybe ?

Is the BINDER 5pin male the round shape connector ?

Regards,
Ludovic


I would have expected it to come with the unit, but I have a wiring
diagram (includes other LX recorders as well) which I will post at:

http://www.spsys.demon.co.uk/temp/LX-wiring.pdf