View Single Post
  #2  
Old March 25th 05, 04:24 PM
BobR
external usenet poster
 
Posts: n/a
Default


ELIPPSE wrote:
I used EAR Specialties Confor foam in my plane's seats. I laminated

the
three softest 1/2" plies behind my back with a lumbar piece, all four
1/2" ply grades under my legs, and five 1/2" plies under my butt; two
of the hardest, two of the next softer, and one of the next softest.
Even with a wallet in my back pocket there are no pressure points,
which on my five and six hour x-country flights is a real blessing!
Look on McMaster-Carr catalog page 3304, www.mcmaster.com. They get
hard when cold, but will soften and conform as your bod warms them

up.
I highly recommend this foam for your seats if you do much
long-endurance flights. I think McMaster's prices are less than

you'll
find in ACS. Several of us went together to buy them through the
factory to meet their minimum purchase amount. EAR also has a

complete
line of sound-absorbing material for aircraft, and a booklet on their
use.


Not only is McMaster-Carr a good source for the Confor foam, it is an
great source for the sound-absorbing material. I got a super light
weight sound absorbing foam for lining my interior from McMaster-Carr.
The stuff is self-extinquishing and gives off no toxic gases. I got a
roll of 1/8 inch and 1/4 inch which only weight a couple of pounds per
roll. Check them out and be prepared to take delivery when you order.
In most cases, my orders from McMaster-Carr were delivered within 24
hours of placing the order.