On 6 Jun 2005 09:39:45 -0700, wrote:

Is there a simple (or complex) guideline for the relationships between
CG, pivot axis and aerodynamic center for a control surface to prevent
flutter?

Is it as simple as keeping the CG at or ahead of the aerodynamic
center, similar to designing for stability of the aircraft itself?

basically that is it.
ailerons have an added complexity that while they need to be balanced,
the overall wing also needs balance in the correct position.(typically
ahead of the main spar)

not all surfaces on all aircraft are actually fully balanced. the
ailerons on a cessna 150 are balanced on the hinge line with a bar of
lead rivetted onto the frise lip. the rudder and stabiliser have a
specification for the maximum amount of allowable unbalance.

Vne is the normal never exceed speed. Vd is the dive speed which is
established by test flying. it is the maximum speed that can be flown
before the onset of flutter (or by other structural limits) and is
determined by very careful test flying. Vne is set at 90% of Vd for
safety.

so you can build in flutter proofing by balance, absence of hinge slop
and control tensions but in the end it is up to some careful test
flying to determine whether there is an onset of flutter.

hope this helps
Stealth Pilot