Udo Rumpf wrote:
In that case I will restate my inquiry.
I am aware of the conventional corrosion protection regarding alu.
The top surfaces have been look after.
I am looking for a product that will protect the "bottom" of an alu
trailer.
It should be able to seep into, as well as creep in-between pieces of
alu that have been riveted. (HL) I will not take the trailer apart to get
at
the crevices. Either spray or brush on will be a good solution
The trailer is built and conventional alu protection on bottom of the
trailer can not be used.
I hope this is more precise
Regards
Udo


WD-40 was created for pretty much this type of thing. It obviously
won't repair corrosion,but likely will slow it down. It does wick into
crevices.
UH

"HL Falbaum" wrote in message
...
Actually, the poster covers the question--stating there is no "shortcut"
to stabilizing the corrosion. It "hides" in crevices and comes out later.
The "glider deserves it" refers to the protection an intact trailer bottom
affords a glider.

Hartley Falbaum

"Udo Rumpf" wrote in message
.. .
At last some one read the post.
In an attempt to be helpful one keys in on a few words.
Udo

I believe the original post was about the bottom of the trailer instead
of the glider.

Larry



" wrote in message
:

I would only add two things to the above response. I would use an
etching solution such as Alumiprep 33 or Turco with the ScotchBrite,
rinse, then coat with Alodine, rinse and prime with a Zinc Chromate
paint before topcoating with a two part polyurethane. It's a lot of
work but your glider deserves it.

As for the shortcut solution, there are coatings which would protect
the surface but (at least for aluminium) I haven't seen anything that
would stabilize the corrosion that is already there.