John T wrote:

Whatcha need to do is take a little scrap of aluminum with the correct
size hole in it. When you put the cleco through your part, you put the
scap on the end of the cleco and that will "clamp" the parts to your cleco.

John


Doesn't help if he's closing a part or has a bunch of holes that need
clecos. If he really needs to do as you suggest washers are cheap and
smaller than you the scrap you suggest. I can't imagine a situation
where one would need to use a back up if one is using proper proceedure
and good tools.

Dan, U.S. Air Force, retired