On 28 Oct 2005 16:13:51 -0700,
wrote:
Hello everyone - my first posting here.
I'm in the process of equipping my Earthstar thundergull with avionics.
This is a very light tandem 2 seater.
I was wondering what type of navcom to go with...handheld or panel
mounted.
Well...it's not exactly an "either/or" situation. Check out the panel mounting
of an ICOM IC-A5 in my Fly Baby:
http://www.wanttaja.com/hhrad2.JPG
The radio is wired to conventional panel jacks, and is powered by the aircraft
12V bus by a "Battery Eliminator" purchased from Batteries America. No
modifications to the radio were needed...I just built a cage from 1.25" aluminum
channel (actually square tubing with one side cut away) and purchased the
four-conductor plug that fits into the headset adaptor jack for about $7.
The radio assembly is essentially self-contained...the headset jacks mounted
onto the side rails of the aluminum channel. The only wiring on the airplane
was a 4-conductor plug for power and PTT switch (plus the antenna, of course).
http://www.wanttaja.com/hhrad.JPG
The potentiometer is used to adjust the volume without being able to access the
knob on top. Everyone seems to understand me (quite unlike RAH :-), I can
receive stations 75 miles away, and whole installation weighs less than a pound
and cost less than $300.
I made a couple of postings about it to the Fly Baby mailing list:
http://groups.yahoo.com/group/flybabylist/message/5006
Ron Wanttaja