Lew Hartswick wrote:
Shawn wrote:

Some claim UV light can penetrate a fiberglass top and that the
accumulated irradiation of the glider will cause damage to the ship.
Shawn

Have any of "some" ever done a transmission spectra of the material?
Fat chance. Even window glass cuts of about 400 nm.
...lew...

I suspect some UV gets through fiberglass cloth, it is a woven material,
after all. Not all fiberglass trailer tops are created equally. Some
are a few layers of glass supported by a steel tube frame, some are free
standing glass/foam/glass sandwiches. Some have gelcoat on the outside,
some are painted with polyurethane or acrylic. Some have dark opaque
paint on the inside, some are just left bare.

I had a trailer with a sandwich top, polyurethane on the outside, pretty
grey spackle paint on the inside. I could read a book by the light that
came through the top when I was closed up inside (the glider was also
painted with polyurethane, however, no gelcoat to damage). I had
another trailer with a sandwich top, gelcoat outside, thick dark gray
paint inside, it was totally dark inside. I had yet another trailer
with glass on steel frame, the gelcoat deteriorated, so I had it sanded
and repainted in white automotive acrylic. Within a year or two it was
obvious which parts of the glider were facing upwards in the trailer, as
those parts were distinctly yellower. I've seen a glider which had
badly crazed gelcoat just in those areas that face upward in its
fiberglass top trailer.

An aluminum top protects the glider from UV, even without paint. If I
were to roll the trailer with the glider inside, I'd rather have an
aluminum top. If I lived in a damp warm area, I'd rather have a
fiberglass sandwich top with dark paint on the inside, as there would
likely be a lot less condensation inside the trailer...

Marc