Did you try the CH Map program that came with the unit? It is a very nice
program and works well. The CHMap allows you to do do basic or more
advanced control schemes..

Or you can just go into the FS controls setup and assign the axis there.

James Jahns wrote:

I need direction to a map written for the Control Manager which
includes the yoke pedals and throttle quadrant - ideally the map
should include set ups for 1,2,3,or 4 engine jets, turbos and piston.
I can't believe that CH products doesn't have a programmer employed
that could supply their products with user friendly software that works.

--
Brett I. Holcomb

Remove R777 to email