Hey guys, take a piece of cardboard big enough to cover the bottom of your
baggage compartment and make a stencil of the floor. Then design your
plywood pieces to cover the floor of the baggage compartment completely and
snuggly. If you want to get fancy, rabbit joint the edges so they lay on
top of each other. It'll make a great support platform for the baggage and
spread the load out over the entire floor area.

When we pulled the floor out of the rear baggage compartment of our Aztec,
we found two support stringers that were broken at the ends (where they
rivet to the side stringers). That piece of plywood is now a permanent
member of our W&B, in fact, I even upholstered it and it blends right in.

Jim

"Montblack" wrote in message
...
("john smith" wrote)
Do you use grass airstrips? Are you going to AirVenture?
Cut three 1-foot x 1-foot squares of marine plywood (not particle board)
of one-inch thickness. Stop just short of where you park the airplane.
Climb out, pull out the boards, place them ahead of each wheel. With
help, pull the airplanes wheels onto the plywood. When you are ready to
leave, pull the airplane off the plywood and stow them away for the next
use. This prevents yours wheels form sinking into the ground and
requiring high engine power to pull the airplane free from the ruts.
Montblanc may be selling them at the R.A.P gathering this summer at
AirVenture.


1-ft x 1-ft square was found to be somewhat ...ungood. I would recommend
at
least 1-ft x 18 inches.

I'll have to start saving scraps of plywood. For long term use, marine
plyw$$d is great! For one week at OSH ...we'll see what I find.

Cost? Free.


Montblack