Have you created anything "home-made" for your plane? (or a low cost alternative?)
"Jim Burns" wrote in message
...
Use two different diameters, say a 2 1/2" and a 3", cut in half
lengthwise.
Use one of each per set, they'll stack inside each other that way. As far
as friction, the tire should put enough down pressure against the top of
the
arch so that the cut edges dig in sufficiently, if not, a smaller diameter
may work better.
I think he may be missing the part where you use only 1/2 of the pipe?
--
Jim in NC
|