"Kyle Boatright" wrote in message
. ..
One of these days, I'm gonna dust off the Hatz project, and when I do,
I'll need to make some scarf joints in 1/16" ply.

Suggestions?

KB

Kyle........

It's not a big deal and you do not need a fixture. A scarf for 1/6" ply is
1" wide. Make a pencil line on each area to be scarfed 1" back from the
edge. Draw a bunch of lines from that mark to the edge to give you a visual
when you are removing wood.

Using a quick-clamp, clamp the ply to the workbench in front of you so the
right edge of the ply is at or just a BCH over the right edge of the work
surface. Using a razor sharp 5" or 6" plane, taper the edge of the ply
evenly from the mark to the edge. The plies will become visible as you
remove the material and give you and excellent guide to keep it even.

It takes only a few seconds to make a perfect scarf this way and you'll
enjoy the process.

Rich S.