On Sun, 1 Oct 2006 23:12:42 -0700, "NW_Pilot"
wrote in
:


"Larry Dighera" wrote in message
.. .
On 1 Oct 2006 06:47:05 -0700, "Jay Honeck" wrote
in om:

http://www.alexisparkinn.com/nwpilot's_tranatlantic_flight.htm

Man, if the new details of his story doesn't chill ya, nothing will!

A more experienced pilot who had studied the aux tank system may have
been able to mentally diagnose the cause of the fuel venting. But
Garmin's role in this incident is unforgivable.

I did study the fuel system

Given the fact that the aux fuel system was a modification upon which
your safety depended, did you personally take the time to analyze its
intended operation from the schematic diagram and description of
system operation (not its use, but how it was engineered to operate)?
I believe you are intelligent enough to have done a reasonable job of
system analysis without benefit of specific training or an appropriate
college degree.

and so did the engineer that designed it and
wrote the instructions for it's usage! I would also assume so did the faa
inspector that approved the system description and usage instructions. Once
you go changing the factory fuel system design you go from the engineered
description of the now modified fuel system.

If I understand your story correctly, the cause of the wing tank
venting was a result of the fuel return line pouring fuel that was
being feed from the separate aux tank fuel system into the wing
tank(s). Is that correct?

They left out something very very important in the new systems description!

Are you referring to the necessity to burn fuel from the wing tanks
before switching to the aux tank, so that there would be adequate room
in the wing tanks to hold the fuel being returned from the fuel
injection system?

Can you provide the manufacturer's name and model number for the aux
fuel system installed in the aircraft you delivered?

How large is the documentation of the aux fuel system? Is it possible
you could make a scanned copy available? In particular, I'd like to
see a schematic drawing of the system and the description of its
operation, and its operation use instructions, in that order.