: Not NeverSeize but pipedope, but I tend to agree. Another trick that
: comes to mind is a large American Beauty soldering iron applied to
: the plug, getting it hot enough to disrupt the pipe dope. (The iron
: will not melt the case so that's no worry.)

: You are better off heating the crankcase area with a heat gun and
: turning the plug with the Allen wrench. Heating the plug will just
: expand the plug into the case, whereas heating the case will expand the
: aluminum away from the plug.

Or a corollary might be to run the engine long enough to heat the case and
then apply ice or dry ice only to the plug.

-Cory

--

************************************************** ***********************
* Cory Papenfuss, Ph.D., PPSEL-IA *
* Electrical Engineering *
* Virginia Polytechnic Institute and State University *
************************************************** ***********************