" wrote

Which is why they wire them for 220. It can be a lot.
If you can get 220v to the location, you will be a happy
camper.

I have such an air compressor, and it likes 220 the best. g

It starts quicker, and runs a little cooler, when running continuously. It is
possible to run it on a longer extension cord (made up for 220, of course)
without line loss being such an issue.

I have made up an assortment of pigtails to plug into dryer outlets, and welder
outlets. Yes, it is not protecting at the correct amps, but monitored, it is
not much of an issue, I think. A dead short will still kick even a 50 amp
breaker.

If yours is like mine, it pulls almost 15 amps running, and more at start. It
is necessary to have it's own circuit, if you want to run much else with it on
the same circuit.

My vote? Put up with the inconvenience (at times when you are using it away
from the shop) and run it on 220. It should last longer, and be happier.

The wire configuration for both voltages should be pictured on the data plate,
or on the cover where the terminals are, that need to be changed.
--
Jim in NC