On Sat, 09 Aug 2003 16:12:58 GMT, Ed Rasimus
wrote:

Buzzer wrote:

Center going out as you got closer to source.If I remember right on
the APR-25 a really strong signal would cause the signal to go to the
outer edge of the scope and curl back in a loop. Lots of strong
signals - lots of loops..

See my previous regarding proximity vs signal strength. Sure, as you
get closer, you get a stronger signal, but the parameter was strength.

Probably why I set the sensitivity of each freq band to x db that
would give y deflection. Instead of x number of yds from sam site
would give a certain deflection since not all sam sites put out the
same exact power?G

No looping. The strobe went out to the limit of the display, that's
all.

Must have looped on the bench due to the loopy technician.