On Sat, 20 Jan 2007 22:49:56 -0600, "Highflyer" wrote:


"DonMorrisey" wrote in message
roups.com...
I'm trying to figure out how and where to buy reamers. I need to
create some 5/8" and 1/2" holes in ultra high molecular weight
polyethylene blocks for my control system. The aileron push tubes
slide thorugh the blocks and the aileron actuators mount in the blocks
as well. The mounting component of my aileron actuator is 5/8", so
when buying the .6250" reamer is that already slightly oversized? I
have been told the holes should be oversized by .002". I have looked
for reamers on line but don't know if what I'm buying is the right
size, there is little or no description for them.

Can someone tell me what I should look for in buying these tools and
where may be the best place to do so?

Thanks. Don


Or, if not MacMaster Carr, Check MHC online. ( Manhattan Supply Company )
They do an unbelieveable job of stocking every thing in their catalog. I
once ordered a six foot long length of 1 1/4 inch ACME threaded rod, with
nuts. It arrived the next day by UPS Ground!

Highflyer
Highflight Aviation Services
Pinckneyville Airport ( PJY )

PS: Note, the Pinckneyville 2007 Flyin is coming up May 18, 19, and 20!
Plan now so you don't miss it. :-)

Please drop me a note off list. I seem to have misplaced your old
address. I don't believe you read the one above very often.

Roger (N833R World's oldest Debonair).
any of my old addresses except the rdhalste one will work.