wrote:
When I replaced mine the soapy water didn't work perhaps because of
the Az temperature causing it to start drying before it was totally in
place. Spray Pam did however. Just wait until your wife is shopping
and borrow hers.

Did you spray Pam on just the extrusion, the stripe, or both?

If your caught please don't tell her I suggested it.

If it makes it easier and quicker, my wife will send you a six pack of
Pam as a gift! We've got one stripe on using the soapy water and 100 deg
F in the sun method, and she was melting into the puddle of soapy water
by the end.

--
Eric Greenwell - Washington State, USA
* Change "netto" to "net" to email me directly
* "Transponders in Sailplanes" http://tinyurl.com/y739x4
* "A Guide to Self-launching Sailplane Operation" at www.motorglider.org