Le Chaud Lapin wrote:


So a different approach might be to stop making finished systems and
instead focus on components. Manufacturers would make controls in
sensors in wide variety, all conforming to USB standard. A (cheap)
commodity PC would be able to control everything. And (licensed)
software developers could do their part.

-Le Chaud Lapin-

That is where your problem is. It all has to be certified as a unit not as
individual components. Like it or not it isn't going to change with anything
short of an armed revolution.

Let me give you an example of FAA thinking.

I'm building and airplane, you can see it at www.peoamerica.net/N601WR.

When I'm done because I'm using a non certified prop and engine combination
I have to test fly it for 40 hours for phase one testing. If I was using an
engine and prop combination that had ever been paired up in a certified
aircraft I would only need to phase one test for 25 hours. Now here's the
kicker. Just because that certified engine and prop were mounted and flown
in an experimental they can never be considered certified again.

Another good example is the IFR GPS certification requirement even in an
experimental. I can install every single piece of electronics in my plane
and if one of those pieces happen to be a Nav/Com with Glide Slope I can fly
it IFR. For that matter I could even build the Nav/Com myself and the FAA
wouldn't care. (yes the FCC would but that is beside the point) But for a
GPS to be used IFR it has to meet the TSO requirements.

That Dynon unit you mentioned is what is going in my plane but even it can't
go into a certified aircraft without a metric butt load of paperwork.

I think deep down you know what the reasons for the cost are but if you
don't I'll tell you.

Volume: There really isn't that big a market.
Certification: Those Dell laptops would never pass the vibration tests
alone.
LIABILITY