Ed Sullivan wrote:
On Wed, 26 Sep 2007 20:33:05 -0700, wrote:



aileron rod, I do not think it sees much load at all--certainly far,
far short of it's rated load. I have seen several planes out there
with rod ends in single shear, so it can't be complete suicide . . .
right? No?

Thank you for your thoughts.

I have a number of them that have been in service for over 20 years,
all with the large washer. Works for me.

Ed Sullivan, Jungster II

Long as teh arm and bolt are stiff enough not to deform - who cares...

The single arm may not have the resistance to twisting that
the two arms do together. You'd want to compare single-arm setups with
what you have. An arm that allows twisting will eventually fail or
might allow enough aileron play to start flutter. Both are bad news.

Dan


As long as the uiball is tight against the bell crank or horn there
will be no play.

:Ed

True, nut not necessarily the whole story, Ed.

Because there is a small moment due to the off-axis pushrod, the
arm itself could flex.

If the arm is really thin metal (as possible if a sheet steel part
were used) it MIGHT be possible to excite the aileron system -
ie: cause flutter.

Richard