On Oct 20, 4:41 am, "Morgans" wrote:
Yes, some air cooled engines have tapered bores (when cold) to allow
for different rates of expansion in cylinder base-to-head so that
it's perfectly cylindrical when up to temp, but i don't know of any
aircraft engines that have that feature.

Really? I thought that they did have a tighter bore at the top. I
guess I read wrong, or remember wrong.

Maybe. I didn't know that they did. It would make sense if they did, all
right. I don't do machining. I just run my fingers over the pretty parts
when they come out of the machine shop!

This ought to be an easy question for someone in the group. Surely, there
is someone that does do machining on engines that hangs out here, that would
know for sure.

Anyone?
--
Jim in NC

Ok, First off don't call me Surely. GGGG.
The concept is question is called "choke bore" and the idea is the
bottom of the cylinder that's close to the case runs at a much lower
temp since combustion happens at the other end. The top end grows at a
greater rate because of this. In theory when the engine is up to temp
the cylinder ends up being pretty straight. I have the specs around
here somewhere but if I remember correctly the bore when cold is in
the .006-.008 smaller at the top. Boring one is usually done by using
a tool post grinder and performing the taper feature is a calculated
process. Honing one with a flex hone is straight forward and easy,
using a Sunnen CK-10 or a CV-616 takes ALOT more practice...

Ben
www.haaspowerair.com