On Sun, 23 Mar 2008 15:15:35 -0400, "Morgans"
wrote:


wrote in message
...
I picked up a project that was supposed to be built with 1.5 degrees
of washout towards the end of the wings. The builder unfortunately
built them without washout, because while his workmanship was actually
quite good he was worried he wouldn't be able to match the wings and
one would drop in a stall.

Before I rebuild the wings, what disadvantages am I looking at keeping
things as they are besides the whole wing stalling at once? Any other
aerodynamical problems? And could I cheat a fix by using VGs on the
outer part of the wing?

Or put a "triangle" shaped addition on the leading edge of the wing's root,
to trip that portion into stall, first.

That's all anyone is after with washout. Keep the outer portion flying,
while the root is stalling.

If it were me, I would probably do a bit of both! g

Advantages of keeping the wing with no washout is that the whole wing will
be lifting at cruise, instead of throwing away part of the outer wing's lift
with added washout.

big john and morgans have it with the triangular strips.

you just tape them on and keep shortening them until you have the
stall chracteristics you need. then you replace the temporaries with
permanent ones.
make both sides identical.
work out where the 3 degree angle of attack neutral point is on the
leading edge and stick them there.

Stealth Pilot