On Oct 30, 5:12*pm, "Gregory Hall" wrote:
"Vaughn Simon" wrote in message

...



"Gregory Hall" wrote in message
...

It looks too much like an irresponsible, hot rod, stunt plane to me.

* Well, you sucked me in at first, so on a troll scale of zero-to-10 you
rate at least a five. *How are things in France?

Vaughn

France? *I don't live in France. I built and used to fly a Rotec Rally 2B
many years ago. It was a tail dragger with a high wing and the motor was
mounted atop the wind with a pusher prop.

When I got it trimmed out correctly at cruise speeds I could lean forward in
the seat to nose it down and lean back in the seat to nose it up. Even as
well-balanced as it was at about half throttle, when the engine quit it
would pitch up immediately and drastically because the high engine placement
and pusher prop had enough leverage so that the proper trim at the tail
counteracted the nose down force of the engine and prop. If you didn't
immediately push the stick way forward when the engine quit it was a matter
of seconds before it would nose up fast and stall and then you would have no
control at all from the stick until it fell for a while and the nose dropped
(thank god for that) so you could gain speed provided you had enough
altitude to get control of it again. But it didn't glide too well being a
single surface wing with wire bracing. Perhaps 2:1 glide ratio. But it was
easy to land with no power but you had to come in hot and steep and at the
last second pull back on the stick and flare it.

It looks to me like the Legacy would act pretty much the same if the engine
quit.

--
Gregory Hall

Oh for gawd sake, you are talking about two totally different designs
and the aerodynamics of the two are totally different. The Lancair is
NOT a pusher and the engine is mounted forward of the CG instead of on
top of it. When the engine quits it will not pitch upward. The plane
you flew had the engine well above the center of gravity with a pusher
prop and as a result produced a force that pushed the nose of the
aircraft down. The two planes would not act pretty much the same at
all. The weight of the engine on the Legacy is forward of the CG and
as a result always pulling the nose of the plane down. The counter to
the nose down is the horizontal stabilizer and the elevator. Look at
the angle of incedence on the Horizontal Stabilizer and you will find
a slight downward angle, not an upward angle as is common on the
wing. This counteracts the force from the weight of the engine. An
engine out condition will not have a significant effect on pitch until
the airspeed changes and that will result in a nose down, not nose up
pull.