On Nov 17, 3:30*pm, brianDG303 wrote:
{It took a lot of fussing around.}

Richard,
thanks for that. The gang at PocketFMS swears up and down it can't be
done so I assumed it was not possible.

Is this fussing that can be explained, or is it beyond us mortals? I
personally could be happy with landscape.

mounts.
I suspect that using the suction cup to stick the 310 to the glass
face of the altimeter won't get much approval. The ball and socket
part of the mount ends in a 1/2" flat that meets the flat of a
tightening knob. If the suction cup support arm was cut away a small
hole could be drilled into flat stock (or the panel itself)and the 310
mount could be attached by by using the tightening knob as a mounting
bolt.

Brian,

Fisrt of all you need SeeYou Mobile installed on the SD Card. Then
start the 310 SeeYou Mobile will run, shut it down and connect with
active sync.

You have to copy the .cab file to the flash drive of you Ipaq 310 and
run it to install. Then run the rotate program it installs.

I will have a cable and power converter kit on my web in a couple of
days to power the 310 from your glider battery.

I will also have mounting solutions with a tilt swivel that connects
to goosenecks or ram mounts that I already sell.

The GPS seems to work OK with the unit sideways, I will do more
testing.

Also I have contacted SeeYou with the information. Some tuning of the
Beta program will be needed to make it look better. But it appears to
work.


Richard
www.craggyaero.com