On Tue, 27 Jan 2009 17:53:06 -0600, "Maxwell" #$$9#@%%%.^^^ wrote:


If someone is considering following the advice of you or your buddy Stealth,
I hope they have plenty of time and money to waste on the project, because
learning metal casting by trial and error is a very lenghty, costly and most
often fruitless endeavor.

strange attitude you have there.
most of my castings have actually been completely successful using the
techniques I describe.

ok contribute something.
how would you go about making an oil burner for the furnace?
here in perth the commercial casters all use oil burners.
my own furnace use a waste oil burner.
how would you do it?

Stealth pilot