"Stealth Pilot" wrote in message
...
On Tue, 27 Jan 2009 17:53:06 -0600, "Maxwell" #$$9#@%%%.^^^ wrote:


If someone is considering following the advice of you or your buddy
Stealth,
I hope they have plenty of time and money to waste on the project, because
learning metal casting by trial and error is a very lenghty, costly and
most
often fruitless endeavor.

strange attitude you have there.
most of my castings have actually been completely successful using the
techniques I describe.

Perhaps you would share some photo of your castings, melting and molding
equipment.



ok contribute something.
how would you go about making an oil burner for the furnace?
here in perth the commercial casters all use oil burners.
my own furnace use a waste oil burner.
how would you do it?

Off topic here, but someone would have to design it first. One would need a
drawing or photo.