On Mar 24, 4:05*pm, AK wrote:
On Mar 24, 12:26*pm, The Real Doctor
wrote:

On 23 Mar, 00:23, AK wrote:

I want to make a small mold I would later use to create a fiberglass
container to hold lead weight. It would be nice if *mold material can
withstand 500 degrees Fahrenheit so I can pour lead into it and then
cover it by fiberglass.

I'm a little puzzled here. When you have filled the mould with lead
and covered it with fibreglass, won't the mould still be in there. Is
that OK?

How big is this thing? How complicated is the shape?

Ian

Ian, I create a mold first then I pour lead into the mold. Later I
break the mold up and I use fiberglass to cover the lead so it is
trapped and I am not exposed to lead dust.

Unless you are planning on eating you lunch off the lead I would not
be too worried by the minuscule exposure. Is this a club ship where
people are going to be moving the weights in and out all day long,
without washing their hands etc? If you are worried by lead exposure,
be careful in venting the area when you cast the lead. And the
exposure to chemicals and fiberglass fibers while encapsulating the
lead in fiberglass may be a larger minuscule health risk than the
small miniscule lead exposure :-) (says man who is hypersensitive to
epoxy).


Darryl