Here's an update on my SN-10 plumbing. I had a little water in my TE
tube. After blowing that out, I did a leak test on the TE and pitot
plumbing. The pitot was air tight but I did find a leak in the TE
system. The temp probe looks good. I will fly today and report back.


as Mar 30, 11:35*am, GARY BOGGS wrote:
My Ilec normaly does a great job calculating the wind while ridge
soaring here in Hood River, Oregon, but for the last few flights it
has not been giving me the correct wind, even with lots of circling.
It was off about 45 degrees all day yesterday. I rebooted it before
the flight but that didn't seem to help. Has any one else seen this
problem and have a fix or am I going to have to send it in again?

Gary Boggs

sd