wrote in message
...
In keeping with Bob's promotion of "flying on the cheap" I offer the
following:

It is pretty obvious that this is a cheap way of cutting metal, but
has anyone run across a way of using this technology to weld? If so
it might open up more options for the impoverished home builder.

http://www.metacafe.com/watch/131306...ld_by_teaybkk/
(kind of long and drug out but a very simple set up and build able by
just about anyone)

I can't imagine that this is anything other than a hoax. What is the fuel,
why are there two lines to the torch, with only one hose hooked to it, how
does that small movement by the bellows produce such a large and even flame,
and the list of questions could go on and on.
--
Jim in NC