On Jun 21, 10:11*am, jsbrake wrote:
Before I make myself out to be too much of an idiot with a mostly-
likely-obvious question... is there a quick quide on the process of re-
profiling? *My search in Google just now was fruitless, so I'm doing
something wrong. *I'm not planning on doing it, but I'm curious about
the process.

Thanks!
- John

Yep.
Reprofiling only.
Identify and fill low areas- usually due to shrink over time.
Identify and remove high areas- rare, but it does happen.
Where are they? Ah that is the question.
Throw in refinishing and that is a whole different question.
The first time you do this you will do well not to make the glider
worse. Many do.
Few do it the second time.
UH