Trying to install PF Sat 06/16/12 before flight testing Sunday.

PF sends NMEA sentences by default at 19200 on the DB9 serial connector. The SN10B manual says it must receive at 4800baud. Which device needs to be set? Is there a way to change to DB9 serial output on the PF (possibly through config file)? Or, will the SN10B "hear it" on the RX line at 19200?

Sent same message to Dave Nadler... yet, he may be too busy right now at the Nationals.

I'd prefer to drive the SN10B with the PF because then I can receive an IGC logger file from the SN10B. This provides a backup to my currently installed Volkslogger.

Walt Rogers, WX

Walt Rogers, WX