"WaltWX" wrote in message
...
Trying to install PF Sat 06/16/12 before flight testing Sunday.

PF sends NMEA sentences by default at 19200 on the DB9 serial connector. The
SN10B manual says it must receive at 4800baud. Which device needs to be set?
Is there a way to change to DB9 serial output on the PF (possibly through
config file)? Or, will the SN10B "hear it" on the RX line at 19200?

Sent same message to Dave Nadler... yet, he may be too busy right now at the
Nationals.

I'd prefer to drive the SN10B with the PF because then I can receive an IGC
logger file from the SN10B. This provides a backup to my currently installed
Volkslogger.

Walt Rogers, WX

Walt Rogers, WX

_______________________
Hi Walt,

The most recent SN10 software upgrades (for a few years) support the option
to set the SN10 to receive GPS data at 19200 baud and send it out to another
device at 19200 baud. So upgrade your SN10 software (if you haven't
already) and setup the SN10 options to receive GPS data at 19200 baud. It
is not the default.

Best Regards,

Paul Remde
Cumulus Soaring, Inc.