On Sunday, September 30, 2012 9:16:24 PM UTC-4, Andrzej Kobus wrote:
Can anyone tell me how CN switches from Cruise to Climb with the

software available (assuming no switch installed)?

In the case of my vario, it showed up with a switch already wired in. A
software update came along about the same time that enabled automatic
switching at 65kts. Unfortunately you can only do one or the other right
now; I couldn't find a config screen in the vario to change that. The change has to be done using their profile generator program on a PC.

The switch was easy to install in the panel, but
it's a pain to have to fiddle with it whenever you want to start working
a thermal. 65kts is just too fast in my plane for searching for lift
down low (it's about MC 1.5kts for me).

This does seem to be a work in progress however. I'm hoping for a circling
detector at some point.

-- Matt